Application of Shear Controlled Orientation Technology to Powder Injection Moulding

Author： Pinwill I. E.   Ahmad F.   Allan P. S.   Bevis M. J.  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.35, Iss.2, 1992-01, pp. : 107-112

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Focus on Powder Injection Moulding

By Hayward A.  

Powder Metallurgy, Vol. 40, Iss. 3, 1997-01 ,pp. : 170-180

Maney Publishing

Access to resources Recommend Favorite

Powder injection moulding and what the designer needs to know

By  

Metal Powder Report, Vol. 58, Iss. 9, 2003-09 ,pp. : 10-11

Elsevier

Access to resources Recommend Favorite

Low viscosity feedstocks for powder injection moulding

By Lapointe F.   Turenne S.   Julien B.  

Powder Metallurgy, Vol. 52, Iss. 4, 2009-12 ,pp. : 338-344

Maney Publishing

Access to resources Recommend Favorite

Joining of two materials by powder injection moulding

By Zhang S. X.   Li T.   Li Q. F.   Pook S. F.   Goh C. W.   Hu Q. J.  

Science and Technology of Welding & Joining, Vol. 14, Iss. 1, 2009-01 ,pp. : 11-19

Maney Publishing

Access to resources Recommend Favorite

Comparison of numerical codes for simulation of powder injection moulding

By Bilovol V. V.   Kowalski L.   Duszczyk J.   Katgerman L.  

Powder Metallurgy, Vol. 46, Iss. 1, 2003-04 ,pp. : 55-60

Maney Publishing

Access to resources Recommend Favorite