Modified metal injection moulding process of 316L stainless steel powders using thermosetting binder

Author： Levenfeld B. Gruzza A. Várez A. Torralba J.M.

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.43, Iss.3, 2000-03, pp. : 233-237

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Injection Moulding of 316L Stainless Steel Powder Using Novel Binder System

By Anwar M. Y. Messer P. F. Ellis B. Davies H. A.

Powder Metallurgy, Vol. 38, Iss. 2, 1995-01 ,pp. : 113-119

Maney Publishing

Access to resources Recommend Favorite

Jetting in metal injection moulding of 316L stainless steel

By Dvorak P. Barriere T. Gelin J. C.

Powder Metallurgy, Vol. 48, Iss. 3, 2005-09 ,pp. : 254-260

Maney Publishing

Access to resources Recommend Favorite

Metal injection moulding of scissors using hardenable stainless steel powders

By Newell M. A. Davies H. A. Messer P. F. Greensmith D. J.

Powder Metallurgy, Vol. 48, Iss. 3, 2005-09 ,pp. : 227-230

Maney Publishing

Access to resources Recommend Favorite

Simulation and Modeling of Sintering Process for 316L Stainless Steel Metal Injection Molding Parts

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 32-37

Trans Tech Publications

Access to resources Recommend Favorite

Equipment for injection moulding of thermosetting materials based on ceramic and metal-ceramic powders

By Novikov N. Ivzhenko V. Popov V. Leshchuk A. Sarnavskaya G.

Powder Metallurgy and Metal Ceramics, Vol. 43, Iss. 9, 2004-09 ,pp. : 538-545

Springer Publishing Company

Access to resources Recommend Favorite