Combined model for prediction of viscosity of powder injection moulding mixes

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.44, Iss.2, 2001-02, pp. : 128-132

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Low viscosity feedstocks for powder injection moulding

By Lapointe F. Turenne S. Julien B.

Powder Metallurgy, Vol. 52, Iss. 4, 2009-12 ,pp. : 338-344

Maney Publishing

Access to resources Recommend Favorite

Focus on Powder Injection Moulding

By Hayward A.

Powder Metallurgy, Vol. 40, Iss. 3, 1997-01 ,pp. : 170-180

Maney Publishing

Access to resources Recommend Favorite

Square Root Wick Debinding Model for Powder Injection Moulding

By Vetter R. van den Brand Horninge W. R. Vervoort P. J. Majewska-Glabus I. Zhuang Z. Duszczyk J.

Powder Metallurgy, Vol. 37, Iss. 4, 1994-01 ,pp. : 265-271

Maney Publishing

Access to resources Recommend Favorite

Viscosity and melt rheology of metal injection moulding feedstocks

By Li Y. Huang B. Qu X.

Powder Metallurgy, Vol. 42, Iss. 1, 1999-01 ,pp. : 86-90

Maney Publishing

Access to resources Recommend Favorite

Powder injection moulding and what the designer needs to know

Metal Powder Report, Vol. 58, Iss. 9, 2003-09 ,pp. : 10-11

Elsevier

Access to resources Recommend Favorite