Influences of sintering atmospheres on densification process of injection moulded gas atomised 316L stainless steel

Author： Li S.   Huang B.   Li D.   Li Y.   Liang S.   Zhou H.  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.46, Iss.3, 2003-10, pp. : 241-245

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental and numerical analysis on sintering behaviours of injection moulded components in 316L stainless steel powder

By Song J.   Barriere T.   Liu B.   Gelin J. C.   Michel G.  

Powder Metallurgy, Vol. 53, Iss. 4, 2010-12 ,pp. : 295-304

Maney Publishing

Access to resources Recommend Favorite

Microstructural and mechanical properties of injection moulded gas and water atomised 17-4 PH stainless steel powder

By Gülsoy H. Ö.   Özbek S.   Baykara T.  

Powder Metallurgy, Vol. 50, Iss. 2, 2007-06 ,pp. : 120-126

Maney Publishing

Access to resources Recommend Favorite

Simulation and Modeling of Sintering Process for 316L Stainless Steel Metal Injection Molding Parts

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 32-37

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and Mechanical Behaviour of Single Pressed and Vacuum Sintered Gas and Water Atomised 316L Stainless Steel Powders

By Lindstedt U.   Karlsson B.  

Powder Metallurgy, Vol. 41, Iss. 4, 1998-01 ,pp. : 261-268

Maney Publishing

Access to resources Recommend Favorite

Tensile Characteristics of Nitrogen Enhanced Powder Injection Moulded 316L Stainless Steel

By Rawers J.   Croydon F.   Krabbe R.   Duttlinger N.  

Powder Metallurgy, Vol. 39, Iss. 2, 1996-01 ,pp. : 125-129

Maney Publishing

Access to resources Recommend Favorite