PM processing of elemental and prealloyed 6061 aluminium alloy with and without common lubricants and sintering aids

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.49, Iss.3, 2006-09, pp. : 240-252

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Sintering and mechanical properties of prealloyed 6061 Al powder with and without common lubricants and sintering aids

By Youseffi M. Showaiter N. Martyn M. T.

Powder Metallurgy, Vol. 49, Iss. 1, 2006-03 ,pp. : 86-95

Maney Publishing

Access to resources Recommend Favorite

Hot deformation of PM Al6061 alloy produced by sintering and powder extrusion

By Asgharzadeh H. Simchi A.

Powder Metallurgy, Vol. 51, Iss. 4, 2008-12 ,pp. : 354-360

Maney Publishing

Access to resources Recommend Favorite

Preparation and Properties of 6061 Aluminium Alloy/Graphite Composites by PM Route

By Jha A. K. Prasad S. V. Upadhyaya G. S.

Powder Metallurgy, Vol. 32, Iss. 4, 1989-01 ,pp. : 309-312

Maney Publishing

Access to resources Recommend Favorite

Effect of Alumina Fibre Content on Properties of PM 6061 Aluminium Alloy Based Composite Materials

By Kaczmar J. W. Kainer K. U.

Powder Metallurgy, Vol. 35, Iss. 2, 1992-01 ,pp. : 133-136

Maney Publishing

Access to resources Recommend Favorite

Sintering behaviour and mechanical properties of PM Al-Zn-Mg-Cu alloy containing elemental Mg additions

By Martín J. M. Gómez-Acebo T. Castro F.

Powder Metallurgy, Vol. 45, Iss. 2, 2002-07 ,pp. : 173-180

Maney Publishing

Access to resources Recommend Favorite