(Ti,W)C–Ni cermets by laser engineered net shaping

Author： Xiong Y.   Kim M.   Seo O.   Schoenung J. M.   Kang S.  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.53, Iss.1, 2010-03, pp. : 41-46

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Liquid Phase Sintering of (Ti,W)C-Ni-Co-Cr Cermets: Microstructure and Abrasive Wear Behavior

By  

Solid State Phenomena, Vol. 2018, Iss. 274, 2018-07 ,pp. : 1-8

Trans Tech Publications

Access to resources Recommend Favorite

Process efficiency measurements in the laser engineered net shaping process

By Unocic R.   DuPont J.  

Metallurgical and Materials Transactions B, Vol. 35, Iss. 1, 2004-02 ,pp. : 143-152

Springer Publishing Company

Access to resources Recommend Favorite

Reciprocating wear response of Ti(C,N)‐Ni 3 Al cermets

By Buchholz S   Farhat Z N   Kipouros G J   Plucknett K P  

Canadian Metallurgical Quarterly, Vol. 52, Iss. 1, 2013-01 ,pp. : 69-80

Maney Publishing

Access to resources Recommend Favorite

Fabrication of carbide-particle-reinforced titanium aluminide-matrix composites by laser-engineered net shaping

By Liu Weiping   DuPont J.  

Metallurgical and Materials Transactions A, Vol. 35, Iss. 13, 2004-03 ,pp. : 1133-1140

Springer Publishing Company

Access to resources Recommend Favorite

Fabrication of Carbide-Particle-Reinforced Titanium Aluminide–Matrix Composites by Laser-Engineered Net Shaping

By Liu Weiping   DuPont J. N.  

Metallurgical and Materials Transactions A, Vol. 35, Iss. 3, 2004-03 ,pp. : 1133-1140

Springer Publishing Company

Access to resources Recommend Favorite