Fabrication of aluminium foam through pressure assisted high frequency induction heated sintering dissolution process: an experimental observation

Author： Mustapha M   Mustapha F   Mamat O   Hussain P  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.54, Iss.3, 2011-07, pp. : 343-353

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Empirical Relationship between Relative Electrical Conductivity and Relative Density of the Al-Foam Fabricated through Pressure Assisted Sintering/Dissolution Process

By  

IOP Conference Series: Materials Science and Engineering, Vol. 17, Iss. 1, 2011-02 ,pp. : 121-139

IOP Publishing

Access to resources Recommend Favorite

Evaluation of oxidation and mechanical properties of nanosized WC-10% Nicrobraz composites consolidated by high frequency induction heated sintering

By Woo K-D   Kang D-S   Moon M-S   Kim S-H   Park S-H   Shon I-J  

Materials Technology: Advanced Performance Materials, Vol. 27, Iss. 1, 2012-02 ,pp. : 39-42

Maney Publishing

Access to resources Recommend Favorite

A new-developed nanostructured Mg/HAp nanocomposite by high frequency induction heat sintering process

By  

IOP Conference Series: Materials Science and Engineering, Vol. 40, Iss. 1, 2012-09 ,pp. : 257-268

IOP Publishing

Access to resources Recommend Favorite

Hardening of the surface plasma jet high-frequency induction discharge of low pressure

By  

IOP Conference Series: Materials Science and Engineering, Vol. 86, Iss. 1, 2015-06 ,pp. : 95-100

IOP Publishing

Access to resources Recommend Favorite

The fracture strength of cryomilled 99.7 Al nanopowders consolidated by high frequency induction sintering

By  

IOP Conference Series: Materials Science and Engineering, Vol. 63, Iss. 1, 2014-08 ,pp. : 213-221

IOP Publishing

Access to resources Recommend Favorite