Density and porosity control of sintered 316L stainless steel parts produced by additive manufacturing

Author： Verlee B   Dormal T   Lecomte-Beckers J  

Publisher： Maney Publishing

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.55, Iss.4, 2012-09, pp. : 260-267

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Deformation and fracture behavior of 316L sintered stainless steel under various strain rate and relative sintered density conditions

By Lee Woei-Shyan   Chiu Chien-Cheng  

Metallurgical and Materials Transactions A, Vol. 37, Iss. 12, 2006-12 ,pp. : 3685-3696

Springer Publishing Company

Access to resources Recommend Favorite

316L Stainless Steel with Gradient Porosity Fabricated by Selective Laser Melting

By Li Ruidi   Liu Jinhui   Shi Yusheng   Du Mingzhang   Xie Zhan  

Journal of Materials Engineering and Performance, Vol. 19, Iss. 5, 2010-07 ,pp. : 666-671

Springer Publishing Company

Access to resources Recommend Favorite

Processing of Sintered Stainless Steel Parts

By Beiss P.  

Powder Metallurgy, Vol. 34, Iss. 4, 1991-01 ,pp. : 259-261

Maney Publishing

Access to resources Recommend Favorite

Analysis of the Fatigue Life of Sintered Porous 316L Steel with Different Density

By  

Solid State Phenomena, Vol. 2014, Iss. 224, 2015-02 ,pp. : 124-129

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and corrosion properties of nitrogen stainless steel 316L produced by hipping

By Abdel-Karim R.   Elmahallawi I.   El-Menshawy K.  

Powder Metallurgy, Vol. 47, Iss. 1, 2004-01 ,pp. : 43-48

Maney Publishing

Access to resources Recommend Favorite