Author： Schneider R. S. E. Mesquita R. A.
Publisher： Maney Publishing
ISSN： 1749-5156
Source： International Heat Treatment & Surface Engineering, Vol.4, Iss.4, 2010-12, pp. : 138-144
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Several new tool steel grades as well as optimised modifications of standard grades have been developed by special steel producers during the last one to two decades. These steels offer the potential for better properties and tool performance, but only if the heat treatment is performed with an optimum combination of parameters. The achievement of this potential is supported by advanced heat treatment equipment and processes. This paper gives an overview of the possibilities, requirements and optimum heat treatment parameters of these new tool steels based on the examples of cold work tool steels. Thereby special attention is paid to 8%Cr steels, spray formed steels, powder metallurgy steels as well as surface hardening and cryogenic treatment. A second part will be published successively, with examples on hot work tool steels and tool steels for plastic moulding.
Related content
By Schneider R S E Mesquita R A
International Heat Treatment & Surface Engineering, Vol. 5, Iss. 3, 2011-09 ,pp. :
Access to resources
Recommend
International Heat Treatment & Surface Engineering, Vol. 1, Iss. 1, 2007-01 ,pp. :
By Krauss G.
International Heat Treatment & Surface Engineering, Vol. 2, Iss. 3-4, 2008-12 ,pp. :