Author： Kovačič B. Kamnik R. Premrov M.
Publisher： Maney Publishing
ISSN： 1752-2706
Source： Survey Review, Vol.43, Iss.320, 2011-04, pp. : 150-161
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
At the Centre for Geodesy of the University of Maribor, Slovenia, we engaged in the measurement and analysis of displacements for the last ten years. We wanted to find the connections between the displacements and the applied loads. Therefore, reliable and accurate results were needed. A reinforced-concrete plate was loaded to 42 kN in pre-calculated steps and the resulting deformations measured by three independent methods. The results were compared to analytical ones. The analyses and calculations of the most suitable method were implemented. An electronic tacheometer, photogrammetry and a pressure length transducer on the hydraulic cylinder were used.
Related content
Measurement and calculation of the emissivity of a high-temperature black body
By Yousef S. Galal Sperfeld P. Metzdorf J.
Metrologia, Vol. 37, Iss. 5, 2000-11 ,pp. :
Access to resources
Recommend
Deformation, Measurement, Analysis and Prediction Conference Fredericton, New Brunswick, Canada
Survey Review, Vol. 29, Iss. 225, 1987-07 ,pp. :