Manufacturing Technology for Apparel Automation - Layup Module Part II: The Impact of Fabric Properties on the Gap Length between Two Slats

Author： Seyam A Sun F

Publisher： Emerald Group Publishing Ltd

ISSN： 0955-6222

Source： International Journal of Clothing Science and Technology, Vol.6, Iss.1, 1994-01, pp. : 3-13

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Manufacturing Technology for Apparel Automation — Lay up Module: PART I: SLAT DESIGN

By Seyam A. Sun F. McPherson E. Clapp T. Little T.

International Journal of Clothing Science and Technology, Vol. 5, Iss. 3-4, 1993-01 ,pp. : 44-59

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Correlation between clothing air gap space and fabric mechanical properties

By Yu Miao Wang Yunyi Wang Yipei Li Jun

Journal of the Textile Institute, Vol. 104, Iss. 1, 2013-01 ,pp. : 67-77

Taylor & Francis Ltd

Access to resources Recommend Favorite

RATIONAL EXPLOITATION OF FABRIC ROLLS IN APPAREL CUTTING TECHNOLOGY

By Knez Blaz

International Journal of Clothing Science and Technology, Vol. 1, Iss. 3, 1989-01 ,pp. : 21-25

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

THE DEVELOPMENT PHASE OF THE TEXTILE/CLOTHING TECHNOLOGY CORPORATION APPAREL AUTOMATION PROJECT

By Tyler D.J.

International Journal of Clothing Science and Technology, Vol. 1, Iss. 2, 1989-01 ,pp. : 11-16

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Fabric Properties as Control Factors for Flexible Apparel Production Systems

By Govindaraj M. Chen B. Koechling J.

International Journal of Clothing Science and Technology, Vol. 4, Iss. 2-3, 1992-01 ,pp. : 34-38

Emerald Group Publishing Ltd

Access to resources Recommend Favorite