Author： Perkin M. Kohler R. Riety P. Skrovanek T. C. E. C. Morris Tilford R. Ehrlich C. D. Ooiwa A. Eichorn G. Jager J. Molinar G. F. Bass A. H. Gupta A. C.
Publisher： IOP Publishing
ISSN： 0026-1394
Source： Metrologia, Vol.35, Iss.3, 1998-06, pp. : 161-173
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
This report summarizes the results obtained by twelve laboratories in a comparison of pressure measurement standards in the range 10 kPa to 140 kPa, carried out under the auspices of the Consultative Committee for Mass and Related Quantities. Measurements were taken in the absolute mode and, by some participants, in the gauge mode. Good repeatability and, until near the end, reproducibility were observed in the transfer standard. The results displayed significant differences between some of the participants beyond those expected from their claimed uncertainties.
Related content
Access to resources
Recommend
New absolute pressure standard in the range 1 Pa to 7 kPa
Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. :
APX50, the first fully automatic absolute pressure balance in the range 10 kPa to 1 MPa
By Poirier F.
Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. :
A primary pressure standard at 100 kPa
By Schmidt J. W. Cen Yueqin Driver R. G. Bowers W. J. Houck J. C. Tison S. A.
Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. :