Dynamic features of planetary gear set with tooth plastic inclination deformation due to tooth root crack

ISSN： 0924-090X

Source： Nonlinear Dynamics, Vol.74, Iss.4, 2013-12, pp. : 1253-1266

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Gear tooth root crack, as one of the popular gear tooth failures, is always caused by the dynamic load or excessive load applied to the tooth. It will devastate the working performance of the gear system, by problems such as vibration and noise, or even lead to a broken tooth, which will stop the normal working process of the gear system. It has attracted wide attention from researchers. However, the previous studies focused their concentration only on the mesh stiffness reduction due to tooth root crack, while the tooth plastic inclination due to tooth bending damages like gear tooth root crack is seldom considered. In this paper, a tooth plastic inclination model for spur gear with tooth root crack is developed by regarding the cracked tooth as a cantilever beam. It influences not only the displacement excitation but also the mesh stiffness and load-sharing factor among tooth pairs in mesh. The simulation results obtained by incorporating the tooth plastic inclination deformation model together with the tooth root crack model into a 21-Degree-of-Freedom planetary gear dynamic model indicate that the tooth plastic inclination has a significant effect on the performance of the gear system rather than the mesh stiffness reduction due to tooth root crack.