The effect of die geometry on the microstructure of indirect squeeze cast and gravity die cast 7050 (Al-6.2Zn-2.3Cu-2.3Mg) wrought Al alloy

Author： Kim S-W Durrant G. Lee J-H Cantor B.

Publisher： Springer Publishing Company

ISSN： 0022-2461

Source： Journal of Materials Science, Vol.34, Iss.8, 1999-04, pp. : 1873-1883

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Microstructure and superplasticity of an Al-Zn-Mg-Cu alloy

By Jiang D. Liu R. Wang C. Wang Z. Imai T.

Journal of Materials Science, Vol. 34, Iss. 14, 1999-07 ,pp. : 3363-3366

Springer Publishing Company

Access to resources Recommend Favorite

Effect of Mg on age hardening and precipitation behavior of an AlSiCuMg cast alloy

By Wang Guiqing Bian Xiufang Liu Xiangfa Zhang Junyan

Journal of Materials Science, Vol. 39, Iss. 7, 2004-04 ,pp. : 2535-2537

Springer Publishing Company

Access to resources Recommend Favorite

Effect of Lanthanum Addition on Fluidity of Complex Al-11Si-Cu-Mg Cast Alloy

Advanced Materials Research, Vol. 2015, Iss. 1119, 2015-08 ,pp. : 490-494

Trans Tech Publications

Access to resources Recommend Favorite

Properties of squeeze cast Mg-10Al-Mn alloy and its alumina short fibre composites

By Jayalakshmi S. Kailas S.V. Seshan S.

Journal of Materials Science, Vol. 38, Iss. 7, 2003-04 ,pp. : 1383-1389

Springer Publishing Company

Access to resources Recommend Favorite

Tensile Properties of Squeeze Cast Mg-Al-Sr Alloy under Applied Pressures

Advanced Materials Research, Vol. 2015, Iss. 1088, 2015-03 ,pp. : 181-185

Trans Tech Publications

Access to resources Recommend Favorite