The manufacturing of thermoplastic composite parts by water-assisted injection-molding technology

By Liu S.-J.   Chen Y.-S.  

Composites Part A: Applied Science and Manufacturing (Incorporating Composites and Composites Manufacturing), Vol. 35, Iss. 2, 2004-02 ,pp. : 171-180

Elsevier

Access to resources Recommend Favorite

The role of gas penetration on morphological formation of polycarbonate/polyethylene blend molded by gas-assisted injection molding

By Zheng Guo-Qiang   Yang Wei   Huang Li   Li Zhong-Ming   Yang Ming-Bo   Yin Bo   Li Qian   Liu Chun-Tai   Shen Chang-Yu  

Journal of Materials Science, Vol. 42, Iss. 17, 2007-09 ,pp. : 7275-7285

Springer Publishing Company

Access to resources Recommend Favorite

Lamellar orientation in the blends of linear low density polyethylene and isotactic polypropylene induced by dynamic packing injection molding

By Wang Yong   Na Bing   Zhang Qin   Tan Hong   Xiao Yan   Li Liangbin   Fu Qiang   Men Yongfeng  

Journal of Materials Science, Vol. 40, Iss. 24, 2005-12 ,pp. : 6409-6415

Springer Publishing Company

Access to resources Recommend Favorite

Review of Factors that Affect Shrinkage of Molded Part in Injection Molding

By Annicchiarico Daniele   Alcock Jeffrey R.  

Materials and Manufacturing Processes, Vol. 29, Iss. 6, 2014-06 ,pp. : 662-682

Taylor & Francis Ltd

Access to resources Recommend Favorite

Interfacial crystallization of isotactic polypropylene molded against the copper surface with various surface roughnesses prepared by an electrochemical process

By Lin C.W.   Ding S.Y.   Hwang Y.W.  

Journal of Materials Science, Vol. 36, Iss. 20, 2001-10 ,pp. : 4943-4948

Springer Publishing Company

Access to resources Recommend Favorite