Aspects of the Lengthwise Cutting of Rolled Sections by Undriven Rotary Shears in the Mill Line

Author： Fastykovskii A.R.   Peretyat'ko V.N.   Fastykovskii D.A.  

Publisher： Springer Publishing Company

ISSN： 0026-0894

Source： Metallurgist, Vol.47, Iss.3-4, 2003-03, pp. : 120-124

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Ways of improving the speed parameters of drum-type flying shears for cutting flat-rolled products to measured lengths

By Belobrov Yu.   Eletskikh V.   Gritsenko S.  

Metallurgist, Vol. 50, Iss. 11-12, 2006-11 ,pp. : 597-601

Springer Publishing Company

Access to resources Recommend Favorite

Improving high-capacity drum-type flying shears for cutting rolled bars to measured lengths

By Kolesnikov Yu.   Gritsenko S.   Eletskikh V.   Polivanov V.  

Metallurgist, Vol. 48, Iss. 11-12, 2004-11 ,pp. : 565-567

Springer Publishing Company

Access to resources Recommend Favorite

Mastering a technology for the lengthwise cutting of continuous-cast slabs

By Komel’kov E.   Popov A.   Kushnirov I.  

Metallurgist, Vol. 48, Iss. 11-12, 2004-11 ,pp. : 562-564

Springer Publishing Company

Access to resources Recommend Favorite

Aspects of the piercing of shells made of hypereutectoid silumins on a universal 20–60 rotary rolling mill

By Panov E.  

Metallurgist, Vol. 50, Iss. 1-2, 2006-01 ,pp. : 91-101

Springer Publishing Company

Access to resources Recommend Favorite

Press-Shears for Cutting and/or Baling Scrap Metal

By Wientzek Bruno J. J.  

Metallurgist, Vol. 47, Iss. 11-12, 2003-11 ,pp. : 473-476

Springer Publishing Company

Access to resources Recommend Favorite