Analysis of the Process of Explosion Braze-Welding of Heat Exchanger Tube Plates

Author： Vorob'ev Y.S.   Chernobryvko M.V.   Kolodyazhnyi A.V.   Kruszka L.  

Publisher： Springer Publishing Company

ISSN： 0039-2316

Source： Strength of Materials, Vol.34, Iss.4, 2002-07, pp. : 407-411

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analysis on the Mechanical Field of Fixed Tube-Sheet Heat Exchanger

By  

Advanced Materials Research, Vol. 2014, Iss. 1079, 2015-02 ,pp. : 488-491

Trans Tech Publications

Access to resources Recommend Favorite

A heat exchanger tube gets all steamed up

By van Bennekom A.  

Engineering Failure Analysis, Vol. 8, Iss. 2, 2001-04 ,pp. : 133-134

Elsevier

Access to resources Recommend Favorite

Improvement of Containment Spray Heat Exchanger in Structure Analysis

By  

Advanced Materials Research, Vol. 2015, Iss. 1125, 2015-11 ,pp. : 583-587

Trans Tech Publications

Access to resources Recommend Favorite

Estimation of the heat-affected zone for the electron-beam welding of plates

By Skal’s’kyi V.  

Materials Science, Vol. 46, Iss. 1, 2010-09 ,pp. : 115-123

Springer Publishing Company

Access to resources Recommend Favorite

Welding of Aluminum to DP600 Steel Plates by Refill Friction Stir Spot Welding Process (Refill FSSW): Preliminary Results

By  

Advanced Materials Research, Vol. 2014, Iss. 1082, 2015-02 ,pp. : 123-132

Trans Tech Publications

Access to resources Recommend Favorite