Numerical Analysis of the Stressed State and Evaluation of Strength of a Cutting Tool with Thin Coating

ISSN： 0039-2316

Source： Strength of Materials, Vol.35, Iss.1, 2003-01, pp. : 68-77

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Poisson's Ratio on the Limiting Stressed State of a Coating

By Dolgov N.A. Lyashenko B.A.

Strength of Materials, Vol. 34, Iss. 1, 2002-01 ,pp. : 49-53

Springer Publishing Company

Access to resources Recommend Favorite

Deformation and Strength of Malleable Cast Iron in the Complex Stressed State

By Lamashevskii V. Makovetskii I.

Strength of Materials, Vol. 37, Iss. 5, 2005-09 ,pp. : 489-498

Springer Publishing Company

Access to resources Recommend Favorite

Fracture mechanics approaches to coating strength evaluation

By Babu M.V. Kumar R.K. Prabhakar O. Shankar N.G.

Engineering Fracture Mechanics, Vol. 55, Iss. 2, 1996-09 ,pp. : 235-248

Elsevier

Access to resources Recommend Favorite

Granulation of Extruded Plastic Wires: Influence of Tool Coating Properties and Tool Geometry on Cutting Forces and Tool Wear

Advanced Materials Research, Vol. 2016, Iss. 1140, 2016-10 ,pp. : 181-188

Trans Tech Publications

Access to resources Recommend Favorite

Stressed State Analysis for Spiral Bar in Tension with Account of Material Plastic Properties

By Khromov V.G. Polyakov V.V.

Strength of Materials, Vol. 35, Iss. 4, 2003-07 ,pp. : 419-423

Springer Publishing Company

Access to resources Recommend Favorite