Dynamic ductile fracture in aluminum round bars: experiments and simulations

Author： Anvari Majid Liu Jun Thaulow Christian

ISSN： 0376-9429

Source： International Journal of Fracture, Vol.143, Iss.4, 2007-02, pp. : 317-332

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The application of rate-dependent cohesive elements is validated in simulation of ductile fracture in aluminum round bars under dynamic loading conditions. Smooth and notched round bars made of AA6060-T6 are tested and simulated under quasi-static and dynamic loadings. The smooth round bar is modeled using finite elements that obey Gurson–Tvergaard–Needleman (GTN) formulation as the constitutive equation. Comparing with experimental results, corresponding GTN parameters and rate-dependent plasticity of the alloy are obtained. A single strain rate-dependent GTN element with the obtained parameters is examined under different values of stress triaxiality and loading rates. The resulting stress-elongation curves represent the traction separation law (TSL) for cohesive elements and the variations of the maximum traction and the energy absorbed are investigated.The notched round bars are modeled by axisymmetric continuum and cohesive elements. The undamaged bulk material is elastic-visco plastic and the cohesive elements obey the TSL defined from the single element calculations. The experiments are simulated by these models in which the cohesive elements are rate sensitive and automatically obtain the values of the total strain rate from their adjacent continuum elements to update the values of the cohesive strength during the analysis. The results of the analysis, including maximum load, time of failure and diameter reduction are validated with the experimental results. The effects of element size, rate-dependent plasticity of the material and stress triaxiality are also discussed.