The Direct Shear Strength and Dilatancy of Sand–gravel Mixtures

ISSN： 0960-3182

Source： Geotechnical and Geological Engineering, Vol.24, Iss.3, 2006-06, pp. : 523-549

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

A total of 87 direct shear tests in a large direct shear-box apparatus have been used to investigate the strength and dilatancy of sand–gravel mixtures. This paper focuses on the differences in behaviour between a silica sand (yellow Leighton Buzzard sand) and sand–gravel mixtures obtained by adding fractions of two kinds of gravel to the sand. The purpose is to find a relation between the grain-size characteristics of the materials and the shearing resistance. Experimental results are analysed in terms of the frictional and dilatant contributions to the strength of mixtures as a function of their relative density, and are compared with dilatancy theories and empirical equations. The addition of gravel to the mixtures, even at low fractions (less than 0.1 by volume), causes an increase in peak friction angle (Φ ′_peak) which results both from higher dilatancy at failure (ψ_max) and higher constant volume friction angle (Φ ′_cv). Use of the minimum voids ratio (e_min) of the materials allows the data for the two families of mixtures to be normalized and interpreted in terms of Φ ′_cv and the ratio (Φ ′_peak − Φ ′_cv)/ψ_max. The relationships between relative density (D_r), ψ_max and Φ ′_peak − Φ ′_cv are only partly explained on a physical basis, so we develop empirical equations to predict the peak shear resistance of sand–gravel mixtures (up to gravel contents of 0.5) on the basis of easily measurable quantities. Such equations constitute a practical tool to overcome the problems arising from the impracticality of testing coarse material in the standard shear-box apparatus.