Material Removal Rate, Kerf, and Surface Roughness of Tungsten Carbide Machined with Wire Electrical Discharge Machining

Author： Shah Aqueel   Mufti Nadeem   Rakwal Dinesh   Bamberg Eberhard  

Publisher： Springer Publishing Company

ISSN： 1059-9495

Source： Journal of Materials Engineering and Performance, Vol.20, Iss.1, 2011-02, pp. : 71-76

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analysis of Effects of Cutting Parameters of Wire Electrical Discharge Machining on Material Removal Rate and Surface Integrity

By  

IOP Conference Series: Materials Science and Engineering, Vol. 115, Iss. 1, 2016-02 ,pp. : 120-126

IOP Publishing

Access to resources Recommend Favorite

Micro Electrical Discharge Machining of Tungsten Carbide with Ultra-Short Pulse

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 759-764

Trans Tech Publications

Access to resources Recommend Favorite

Machining Performance and Surface Integrity of AISI D2 Die Steel Machined Using Electrical Discharge Surface Grinding Process

By Choudhary Rajesh   Kumar Harmesh   Singh Shankar  

Journal of Materials Engineering and Performance, Vol. 22, Iss. 12, 2013-12 ,pp. : 3665-3673

Springer Publishing Company

Access to resources Recommend Favorite

Characteristics of the rough-cut surface of quenched and tempered martensitic stainless steel using wire electrical discharge machining

By Huang C.   Tu G.   Yao H.   Kuo H.  

Metallurgical and Materials Transactions A, Vol. 35, Iss. 4, 2004-04 ,pp. : 1351-1357

Springer Publishing Company

Access to resources Recommend Favorite

Research of the Basic Physical Regularities of Material Removal in Electrical Discharge Machining of Tool Steel

By  

Key Engineering Materials, Vol. 2017, Iss. 756, 2017-10 ,pp. : 96-106

Trans Tech Publications

Access to resources Recommend Favorite