Increase in the service life of forming surfaces of molding units. Part 2. Study of the effect of operating properties of molding units on their operating life

By Suzdal’tsev E.   Kharitonov D.   Anashkina A.  

Refractories and Industrial Ceramics, Vol. 51, Iss. 2, 2010-09 ,pp. : 95-98

Springer Publishing Company

Access to resources Recommend Favorite

Study on the Improvement of Crystallization in HDPE Induced by High-Molecular-Weight Polyethylene Through Dynamic Packing Injection Molding

By Deng C.   Lei J.   Gao X.   Chen Z.   Shen K.  

Polymer-Plastics Technology and Engineering, Vol. 47, Iss. 7, 2008-07 ,pp. : 716-721

Taylor & Francis Ltd

Access to resources Recommend Favorite

Study of adhesion failure due to molding compound additives at chip surface in electronic devices

By Scandurra Antonino  

Journal of Adhesion Science and Technology, Vol. 15, Iss. 9, 2001-09 ,pp. : 1039-1053

Taylor & Francis Ltd

Access to resources Recommend Favorite

Study of the process for forming microscopic surface bumps with ultra-fine particles

By Endo Yoshishige   Ono Masahiko   Tsubaki Junichiro  

Advanced Powder Technology, Vol. 11, Iss. 1, 2000-03 ,pp. : 99-112

VSP

Access to resources Recommend Favorite

Simulation and Experimental Investigations of Material Distribution in the Sandwich Injection Molding Process

By Patcharaphun Somjate   Mennig Günter  

Polymer-Plastics Technology and Engineering, Vol. 45, Iss. 6, 2006-01 ,pp. : 759-768

Taylor & Francis Ltd

Access to resources Recommend Favorite