Substituting tube-hydroformed parts for automotive stampings: An economic model

Author： Constantine Bruce   Roth Richard   Clark Joel  

Publisher： Springer Publishing Company

ISSN： 1543-1851

Source： JOM, Vol.53, Iss.8, 2001-08, pp. : 33-38

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

On the Friction Effect on the Characteristics of Hydroformed Tube in a Square Section Die: Analytical, Numerical and Experimental Approaches

By  

Key Engineering Materials, Vol. 2015, Iss. 639, 2015-04 ,pp. : 83-90

Trans Tech Publications

Access to resources Recommend Favorite

Hardmetal for small automotive parts—new growth area?

By  

Powder Metallurgy, Vol. 45, Iss. 1, 2002-02 ,pp. : 15-15

Maney Publishing

Access to resources Recommend Favorite

Wear resistant sintered aluminium parts for automotive applications

By Pohl Angelika  

Powder Metallurgy, Vol. 49, Iss. 2, 2006-06 ,pp. : 104-106

Maney Publishing

Access to resources Recommend Favorite

Development of Thermoplastic Composites for Visible Parts in Automotive

By  

Key Engineering Materials, Vol. 2017, Iss. 742, 2017-08 ,pp. : 62-69

Trans Tech Publications

Access to resources Recommend Favorite

Hybrid forming processes for production of lightweight high strength automotive panel parts

By Mohamed M. S.   Lin J.   Wang L.   Balint D.  

International Heat Treatment & Surface Engineering, Vol. 4, Iss. 4, 2010-12 ,pp. : 160-165

Maney Publishing

Access to resources Recommend Favorite