Rheological behavior of Al-Mg-Si-Cu alloys in the mushy state obtained by partial remelting and partial solidification at high cooling rate

Author： Fabrègue D.   Deschamps A.   Suéry M.   Poole W.  

Publisher： Springer Publishing Company

ISSN： 1543-1940

Source： Metallurgical and Materials Transactions A, Vol.37, Iss.5, 2006-05, pp. : 1459-1467

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Solution Heat Treatment of Rheo-High Pressure Die Cast Al-Mg-Si-(Cu) 6xxx Series Alloys

By  

Solid State Phenomena, Vol. 2014, Iss. 217, 2015-01 ,pp. : 259-7

Trans Tech Publications

Access to resources Recommend Favorite

The Mechanical Properties of Rheo-High Pressure Die Cast Al-Mg-Si-(Cu) 6xxx Series Alloys

By  

Solid State Phenomena, Vol. 2014, Iss. 217, 2015-01 ,pp. : 61-66

Trans Tech Publications

Access to resources Recommend Favorite

Swelling during liquid phase sintering of Al–Mg–Si–Cu alloys

By Crossin E.   Yao J.-Y.   Schaffer G. B.  

Powder Metallurgy, Vol. 50, Iss. 4, 2007-12 ,pp. : 354-358

Maney Publishing

Access to resources Recommend Favorite

Influence of alloy composition, solidification rate and artificial aging on plastic deformation behaviour of Al-Si-Cu-Mg casting alloys

By Sjölander E   Seifeddine S  

International Journal of Cast Metals Research, Vol. 26, Iss. 1, 2013-02 ,pp. : 28-36

Maney Publishing

Access to resources Recommend Favorite

On the precipitation-hardening behavior of the Al−Mg−Si−Cu alloy AA6111

By Esmaeili S.   Wang X.   Lloyd D.   Poole W.  

Metallurgical and Materials Transactions A, Vol. 34, Iss. 13, 2003-03 ,pp. : 751-763

Springer Publishing Company

Access to resources Recommend Favorite