Effect of the Amount of Gases on the Foaming Efficiency of Porous Aluminum Using Die Castings Fabricated by Friction Stir Processing

Author： Hangai Yoshihiko   Kato Hiroki   Utsunomiya Takao   Kitahara Soichiro  

Publisher： Springer Publishing Company

ISSN： 1543-1940

Source： Metallurgical and Materials Transactions A, Vol.41, Iss.8, 2010-08, pp. : 1883-1886

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Vertical Wall on an Aluminum Alloy Plate Fabricated by Friction Stir Forming

By  

Key Engineering Materials, Vol. 2017, Iss. 748, 2017-09 ,pp. : 202-206

Trans Tech Publications

Access to resources Recommend Favorite

The Use of Friction-Stir Technology to Modify the Surfaces of AM60B Magnesium Die Castings

By Santella Michael   Frederick Alan   Degen Cassandra   Pan Tsung-Yu  

JOM, Vol. 58, Iss. 5, 2006-05 ,pp. : 56-61

Springer Publishing Company

Access to resources Recommend Favorite

Porous Alumina Processing Using the Direct Foaming Technique Based on Slurry Boiling

By  

Key Engineering Materials, Vol. 2018, Iss. 766, 2018-06 ,pp. : 1-6

Trans Tech Publications

Access to resources Recommend Favorite

Cylindrical Pin Embossment on A5083 Aluminum Alloy Substrate Fabricated by Friction Stir Forming

By  

Key Engineering Materials, Vol. 2017, Iss. 730, 2017-03 ,pp. : 253-258

Trans Tech Publications

Access to resources Recommend Favorite

Processing Parameters and Microstructure of 6mm 6061 Aluminum Alloy Joints by Friction Stir Welding

By  

Key Engineering Materials, Vol. 2017, Iss. 739, 2017-07 ,pp. : 50-55

Trans Tech Publications

Access to resources Recommend Favorite