Chemical Changes at the Interface Between Low Carbon Steel and an Al-Si Alloy During Solution Heat Treatment

Author： Zhe M.   Dezellus O.   Gardiola B.   Braccini M.   Viala J.  

Publisher： Springer Publishing Company

ISSN： 1547-7037

Source： Journal of Phase Equilibria & Diffusion, Vol.32, Iss.6, 2011-12, pp. : 486-497

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The heat-transfer coefficient during the unidirectional solidification of an Al-Si alloy casting

By Griffiths W.  

Metallurgical and Materials Transactions B, Vol. 30, Iss. 3, 1999-06 ,pp. : 473-482

Springer Publishing Company

Access to resources Recommend Favorite

Research on the Selection of Heat Treatment Parameters of Casting Aluminum Alloy AlSi5Mg Type

By  

Key Engineering Materials, Vol. 2016, Iss. 682, 2016-03 ,pp. : 91-98

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Cr and Mn Addition and Heat Treatment on the Corrosion Behaviour of an AlSi3Mg Alloy

By  

Key Engineering Materials, Vol. 2017, Iss. 754, 2017-10 ,pp. : 11-14

Trans Tech Publications

Access to resources Recommend Favorite

The debonding and fracture of Si particles during the fatigue of a cast Al-Si alloy

By Gall Ken   Yang Nancy   Horstemeyer Mark   McDowell David   Fan Jinghong  

Metallurgical and Materials Transactions A, Vol. 30, Iss. 12, 1999-12 ,pp. : 3079-3088

Springer Publishing Company

Access to resources Recommend Favorite

Effect of post-weld heat treatment on joint properties of friction welded joint between brass and low carbon steel

By Kimura M.   Kusaka M.   Kaizu K.   Fuji A.  

Science and Technology of Welding & Joining, Vol. 15, Iss. 7, 2010-10 ,pp. : 590-596

Maney Publishing

Access to resources Recommend Favorite