VII. METHOD OF MOULDING A CYLINDER IN DRY SAND AT THE BATH IRON WORKS

Author： Leonard S. H.  

Publisher： American Society of Naval Engineers

ISSN： 0099-7056

Source： Journal of the American Society of Naval Engineers, Vol.4, Iss.2, 1892-05, pp. : 159-172

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

THE BATH IRON WORKS

By NEWELL JOHN R.  

Journal of the American Society of Naval Engineers, Vol. 73, Iss. 4, 1961-11 ,pp. : 655-664

American Society of Naval Engineers

Access to resources Recommend Favorite

A Resource Center for Crosscut Initiatives: A Collaborative Effort of Avondale, Bath Iron Works, Cascade General, Electric Boat, NASSCO, Todd Pacific, and UMTRI

By Davis Carol A.  

Journal of Ship Production, Vol. 17, Iss. 3, 2001-08 ,pp. : 161-168

Society of Naval Architects and Marine Engineers (SNAME)

Access to resources Recommend Favorite

METHOD OF MENDING CRACK IN CYLINDER FLANGE

By Bartlett F. W.  

Journal of the American Society of Naval Engineers, Vol. 26, Iss. 3, 1914-08 ,pp. : 769-770

American Society of Naval Engineers

Access to resources Recommend Favorite

THE TALBOT STEEL PROCESS AT THE PENCOYD IRON WORKS

By  

Journal of the American Society of Naval Engineers, Vol. 12, Iss. 1, 1900-02 ,pp. : 152-154

American Society of Naval Engineers

Access to resources Recommend Favorite

ALIGNMENT OF SHAFTING AND BORING OUT STERN TUBES, AS PRACTICED AT UNION IRON WORKS.

By Morgan Leo  

Journal of the American Society of Naval Engineers, Vol. 5, Iss. 1, 1893-02 ,pp. : 7-10

American Society of Naval Engineers

Access to resources Recommend Favorite