A Review of the Machinability of Copper-Base Alloys

ISSN： 0008-4433

Source： Canadian Metallurgical Quarterly, Vol.35, Iss.1, 1996-01, pp. : 1-15

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of permeability on the grain refinement induced by forced convection in copper-base alloys

By Campanella T. Charbon C. Rappaz M.

Scripta Materialia, Vol. 49, Iss. 10, 2003-11 ,pp. : 1029-1034

Elsevier

Access to resources Recommend Favorite

Wear response of a Zn-base alloy in the presence of SiC particle reinforcement: A comparative study with a copper-base alloy

By Prasad B. Das S. Modi O. Jha A. Dasgupta R. Yegneswaran A.

Journal of Materials Engineering and Performance, Vol. 8, Iss. 6, 1999-12 ,pp. : 693-700

Springer Publishing Company

Access to resources Recommend Favorite

Machinability of hypereutectic silicon-aluminum alloys

By Tanaka T. Akasawa T.

Journal of Materials Engineering and Performance, Vol. 8, Iss. 4, 1999-08 ,pp. : 463-468

Springer Publishing Company

Access to resources Recommend Favorite

Production Methods for Powders of Copper and Copper Alloys: A Critical Review

By Mowbray G. A.

Powder Metallurgy, Vol. 29, Iss. 2, 1986-01 ,pp. : 105-107

Maney Publishing

Access to resources Recommend Favorite

Turning and Drilling Machinability of Recycled Aluminum Alloys

Key Engineering Materials, Vol. 2016, Iss. 710, 2016-10 ,pp. : 77-82

Trans Tech Publications

Access to resources Recommend Favorite