Application of Hot Workability Studies to Extrusion Processing. Part III: Physical and Mechanical Metallurgy of Al–Mg–Si and Al–Zn–Mg Alloys

Author： McQueen H.J.   Celliers O.C.  

Publisher： Maney Publishing

ISSN： 0008-4433

Source： Canadian Metallurgical Quarterly, Vol.36, Iss.2, 1997-04, pp. : 73-86

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Application of Hot Workability Studies to Extrusion Processing: Part II. Microstructural Development and Extrusion of Al, Al–Mg, and Al–Mg–Mn Alloys

By McQueen H. J.   Celliers O. C.  

Canadian Metallurgical Quarterly, Vol. 35, Iss. 4, 1996-10 ,pp. : 305-319

Maney Publishing

Access to resources Recommend Favorite

Constitutive relationships for AlZnMg, AlZnMgCr, and AlZnMgZr alloys

By Rønning Bjørn   Ryum Nils  

Metallurgical and Materials Transactions A, Vol. 32, Iss. 13, 2001-03 ,pp. : 769-776

Springer Publishing Company

Access to resources Recommend Favorite

Constitutive Relationships for AlZnMg, AlZnMgCr, and AlZnMgZr Alloys

By Rønning Bjørn   Ryum Nils  

Metallurgical and Materials Transactions A, Vol. 32, Iss. 3, 2001-03 ,pp. : 769-776

Springer Publishing Company

Access to resources Recommend Favorite

Failure of Al-Mg-Si Alloys in Bending

By Friedman P.A.   Luckey S.G.  

Practical Failure Analysis, Vol. 2, Iss. 1, 2002-02 ,pp. : 33-42

Springer Publishing Company

Access to resources Recommend Favorite

Fluidity evaluation methods for Al–Mg–Si alloys

By Di Sabatino M.   Arnberg L.   Brusethaug S.   Apelian D.  

International Journal of Cast Metals Research, Vol. 19, Iss. 2, 2006-04 ,pp. : 94-97

Maney Publishing

Access to resources Recommend Favorite