Study of Powder Injection into Water Using an On-Line Particle Detection System

Author： Yamanoglu Guler   Guthrie R. I. L.   Mazumdar Dipak  

Publisher： Maney Publishing

ISSN： 0008-4433

Source： Canadian Metallurgical Quarterly, Vol.38, Iss.1, 1999-01, pp. : 61-80

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of nickel boride and boron additions on sintering characteristics of injection moulded 316L powder using water soluble binder system

By Bakan H.I.   Heaney D.   German R.M.  

Powder Metallurgy, Vol. 44, Iss. 3, 2001-03 ,pp. : 235-242

Maney Publishing

Access to resources Recommend Favorite

Injection Moulding of 316L Stainless Steel Powder Using Novel Binder System

By Anwar M. Y.   Messer P. F.   Ellis B.   Davies H. A.  

Powder Metallurgy, Vol. 38, Iss. 2, 1995-01 ,pp. : 113-119

Maney Publishing

Access to resources Recommend Favorite

Powder Injection Molding of Mullite: The Study of Mechanical and Physical Properties of the Sintered Products Using Statistical Methods

By  

Key Engineering Materials, Vol. 2016, Iss. 690, 2016-06 ,pp. : 92-96

Trans Tech Publications

Access to resources Recommend Favorite

Powder Injection Molding of Mullite: The Study of Binder Dissolution Behavior during Debinding Step Using Statistical Methods

By  

Key Engineering Materials, Vol. 2016, Iss. 690, 2016-06 ,pp. : 87-91

Trans Tech Publications

Access to resources Recommend Favorite

Injection Moulding of WC–6Co Powder Using Two New Binder Systems Based on Montanester Waxes and Water Soluble Gelling Polymers

By Youseffi M.   Menzies I. A.  

Powder Metallurgy, Vol. 40, Iss. 1, 1997-01 ,pp. : 62-65

Maney Publishing

Access to resources Recommend Favorite