Tailoring microstructure of Mg–Zn–Y alloys with quasicrystal and related phases for high mechanical strength

ISSN： 1468-6996

Source： Science and Technology of Advanced Materials, Vol.15, Iss.4, 2014-08, pp. : 126-141

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Quasicrystal-reinforced Mg alloys

Science and Technology of Advanced Materials, Vol. 15, Iss. 2, 2014-04 ,pp. : 84-92

IOP Publishing

Access to resources Recommend Favorite

Effect of synthesis pressure on hydride phases in Mg–M systems (M=Mn, Y)

Science and Technology of Advanced Materials, Vol. 4, Iss. 4, 2003-07 ,pp. : 60-65

IOP Publishing

Access to resources Recommend Favorite

Joint strength and interfacial microstructure between Sn–Ag–Cu and Sn–Zn–Bi solders and Cu substrate

Science and Technology of Advanced Materials, Vol. 5, Iss. 1-2, 2004-01 ,pp. : 250-259

IOP Publishing

Access to resources Recommend Favorite

Experimental study of the Ca–Mg–Zn system using diffusion couples and key alloys

Science and Technology of Advanced Materials, Vol. 12, Iss. 2, 2011-03 ,pp. : 27-39

IOP Publishing

Access to resources Recommend Favorite

Quantitative characterization of precipitate free zones in Al–Zn–Mg(–Ag) alloys by microchemical analysis and nanoindentation measurement

Science and Technology of Advanced Materials, Vol. 5, Iss. 4, 2004-07 ,pp. : 94-99

IOP Publishing

Access to resources Recommend Favorite