Characterization of the deformation texture after tensile test and cold rolling of a Ti-6Al-4V sheet alloy

Publisher： IOP Publishing

E-ISSN： 1757-899X|82|1|86-89

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.82, Iss.1, 2015-04, pp. : 86-89

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Determination of FLD for Ti-6Al-4V Titanium Alloy Sheet

By  

Key Engineering Materials, Vol. 2016, Iss. 687, 2016-05 ,pp. : 171-178

Trans Tech Publications

Access to resources Recommend Favorite

Comparative Analysis of Forging Rolling and Cross-Wedge Rolling of Forgings from Titanium Alloy Ti6Al4V

By  

Key Engineering Materials, Vol. 2016, Iss. 687, 2016-05 ,pp. : 141-148

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and Texture Evolution During Sub-Transus Thermomechanical Processing of Ti-6Al-4V-0.1B Alloy: Part I. Hot Rolling in (α + β) Phase Field

By Roy Shibayan  

Metallurgical and Materials Transactions A, Vol. 44, Iss. 7, 2013-07 ,pp. : 3303-3321

Springer Publishing Company

Access to resources Recommend Favorite

Deformation Mechanisms of Ti-6Al-4V During Tensile Behavior at Low Strain Rate

By Vanderhasten M.   Rabet L.   Verlinden B.  

Journal of Materials Engineering and Performance, Vol. 16, Iss. 2, 2007-04 ,pp. : 208-212

Springer Publishing Company

Access to resources Recommend Favorite

Cross-Wedge Rolling of Driving Shaft from Titanium Alloy Ti6Al4V

By  

Key Engineering Materials, Vol. 2016, Iss. 687, 2016-05 ,pp. : 125-132

Trans Tech Publications

Access to resources Recommend Favorite