Characterization of Cutting Parameters in the Minimum Quantity Lubricant (MQL) Machining Process of a Gearbox

Publisher： IGI Global_journal

E-ISSN： 2156-1672|5|1|49-60

ISSN： 2156-1680

Source： International Journal of Manufacturing, Materials, and Mechanical Engineering (IJMMME), Vol.5, Iss.1, 2015-01, pp. : 49-60

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Turning of Brasses Using Minimum Quantity of Lubricant (MQL) and Flooded Lubricant Conditions

By Davim J. Paulo  

Materials and Manufacturing Processes, Vol. 22, Iss. 1, 2007-01 ,pp. : 45-50

Taylor & Francis Ltd

Access to resources Recommend Favorite

Minimum Quantity Dry Lubrication in Machining of CFRP

By  

Advanced Materials Research, Vol. 2016, Iss. 1140, 2016-10 ,pp. : 296-303

Trans Tech Publications

Access to resources Recommend Favorite

Characterization of Micromist for Effective Minimum Quantity Lubrication

By  

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 43-46

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Minimum Quantity Lubricant of Al203 Nanoparticle with SDBS on Surface Roughness during Turning of Mild Steel

By  

Advanced Materials Research, Vol. 2015, Iss. 1119, 2015-08 ,pp. : 75-79

Trans Tech Publications

Access to resources Recommend Favorite

Performance Evaluation of Nanographite-Based Cutting Fluid in Machining Process

By Amrita M.   Srikant R. R.   Sitaramaraju A. V.  

Materials and Manufacturing Processes, Vol. 29, Iss. 5, 2014-05 ,pp. : 600-605

Taylor & Francis Ltd

Access to resources Recommend Favorite