Publisher： Edp Sciences
Founded in： 2010
Total resources： 24
E-ISSN： 2107-6847
ISSN： 2107-6839
Subject： T-65 industry codes and standards
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Menu
How to measure test repeatability when stability and constant variance are not observed
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-10 , pp.
Access to resources
Recommend
Temperature effect in the calibration of capacitive humidity sensors
By Carvajal Sergio A.,Sánchez Ciro A. in (2018)
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-10 , pp.Results of the round robin calibration of reference solar cells within the PhotoClass project
By Kröger Ingo,Friedrich Dirk,Winter Stefan,Salis Elena,Müllejans Harald,Pavanello Diego,Hohl-Ebinger Jochen,Bothe Karsten,Hinken David,Dittmann Sebastian,Friesen Gabi,Bliss Martin,Betts Tom,Gottschalg Ralph,Rimmelspacher Lorentz,Stang Johannes,Herrmann Werner,Dubard Jimmy in (2018)
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-10 , pp.By Sariyerli Gokce Sevim,Sakarya Orhan,Akcadag Umit Yuksel in (2018)
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-06 , pp.Occupational health and safety in the Moroccan construction sites: preliminary diagnosis
By Tarik Bakeli,Adil Hafidi Alaoui in (2018)
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-05 , pp.Control chart applications in healthcare: a literature review
By Suman Gaurav,Prajapati DeoRaj in (2018)
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-05 , pp.A new approach to the analysis of Type 1 non-uniqueness of the ITS-90 above 0 °C
By Gaita Sonia,Bonnier Georges in (2018)
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-04 , pp.Linking results of key and supplementary comparisons of AC/DC voltage transfer references
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-04 , pp.Conformity and statistical tolerancing
By Leblond Laurent,Pillet Maurice in (2018)
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-02 , pp.An overview of Quality Management System implementation in a research laboratory
By Molinéro-Demilly Valérie,Charki Abdérafi,Jeoffrion Christine,Lyonnet Barbara,O'Brien Steve,Martin Luc in (2018)
International Journal of Metrology and Quality Engineering , Vol. 9, Iss. issue, 2018-02 , pp.
Previous
Next