Production Time And Cost In High Speed Face Thrning

Author： Gam S. Ben Amar M. Bouzid W. Lahbaieb M.

ISSN： 1066-7857

Source： Materials Technology: Advanced Performance Materials, Vol.21, Iss.3, 2006-09, pp. : 156-163

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Roughness profile in high speed face milling operation

By Louati H. Bouzid W.

Materials Technology: Advanced Performance Materials, Vol. 23, Iss. 4, 2008-12 ,pp. : 231-237

Maney Publishing

Access to resources Recommend Favorite

Cutting Force in High-Speed Face Milling AISI H13 Steel

Key Engineering Materials, Vol. 2015, Iss. 667, 2016-02 ,pp. : 35-40

Trans Tech Publications

Access to resources Recommend Favorite

Nitriding of high speed steel

By Doyle E D Pagon A M Hubbard P Dowey S J Pilkington A McCulloch D G Latham K DuPlessis J

International Heat Treatment & Surface Engineering, Vol. 5, Iss. 2, 2011-06 ,pp. : 69-72

Maney Publishing

Access to resources Recommend Favorite

The production of low-cost titanium powders

By Froes F.

JOM, Vol. 50, Iss. 9, 1998-09 ,pp. : 41-43

Springer Publishing Company

Access to resources Recommend Favorite

Effect of additions on the production cost of steel and the cost-effectiveness of converter steelmaking

By Pak Yu.

Metallurgist, Vol. 55, Iss. 7-8, 2011-10 ,pp. : 558-566

Springer Publishing Company

Access to resources Recommend Favorite