The characterisation of the dimensional change of the Z-axis in NC turning

Author： Segonds S. Landon Y. Mousseigne M. Lagarrigue P.

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.23, Iss.11-12, 2004-06, pp. : 800-805

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Three-half and half-axis patch-by-patch NC machining of sculptured surfaces

By Roman Armando Bedi S. Ismail F.

The International Journal of Advanced Manufacturing Technology, Vol. 29, Iss. 5, 2006-06 ,pp. : 524-531

Springer Publishing Company

Access to resources Recommend Favorite

Three-dimensional characterisation of electronic materials

Surface Engineering, Vol. 11, Iss. 3, 1995-01 ,pp. : 210-211

Maney Publishing

Access to resources Recommend Favorite

Two-dimensional vibration suppression in turning using optimal control of the cutting tool

By El-Sinawi A.H.

International Journal of Machining and Machinability of Materials, Vol. 3, Iss. 1-2, 2008-03 ,pp. : 91-103

Inderscience Publishers

Access to resources Recommend Favorite

Tool probe for measuring dimensional wear and X-coordinate of turning edge

By Szafarczyk M. Chrzanowski J.

The International Journal of Advanced Manufacturing Technology, Vol. 23, Iss. 3-4, 2004-02 ,pp. : 272-278

Springer Publishing Company

Access to resources Recommend Favorite

Integrated inspection and process control for machining a circular contour on a two-axis vertical turning lathe

By Chen A.H. Kurfess T.R.

International Journal of Manufacturing Research, Vol. 1, Iss. 1, 2006-08 ,pp. : 101-117

Inderscience Publishers

Access to resources Recommend Favorite