Related content

Modelling cutting force including thrust and tangential damping in peripheral milling process

By Mehdi Kamel   Zghal Ali  

International Journal of Machining and Machinability of Materials, Vol. 12, Iss. 3, 2012-09 ,pp. : 236-251

Inderscience Publishers

Access to resources Recommend Favorite

Cutting force prediction depending on process parameters by response surface methodology in milling

By Sivasakthivel P.S.   Murugan V. Vel   Sudhakaran R.  

International Journal of Machining and Machinability of Materials, Vol. 11, Iss. 2, 2012-03 ,pp. : 137-153

Inderscience Publishers

Access to resources Recommend Favorite

Feedrate optimization for variant milling process based on cutting force prediction

By Li Z.Z.   Zhang Z.H.   Zheng L.  

The International Journal of Advanced Manufacturing Technology, Vol. 24, Iss. 7-8, 2004-10 ,pp. : 541-552

Springer Publishing Company

Access to resources Recommend Favorite

Analysis and prediction of cutting forces in end milling by means of a geometrical model

By Tsai Chung-Liang  

The International Journal of Advanced Manufacturing Technology, Vol. 31, Iss. 9-10, 2007-01 ,pp. : 888-896

Springer Publishing Company

Access to resources Recommend Favorite

Motion sickness. Part II: experimental verification on the railways of a model for predicting motion sickness incidence

By Braccesi Claudio   Cianetti Filippo   Elia Alessandro  

International Journal of Human Factors Modelling and Simulation, Vol. 2, Iss. 3, 2011-12 ,pp. : 188-203

Inderscience Publishers

Access to resources Recommend Favorite