Related content

Method for rapid characterisation of cutting forces in end milling considering runout

By Segonds Stephane   Landon Yann   Monies Frederic   Lagarrigue Pierre  

International Journal of Machining and Machinability of Materials, Vol. 1, Iss. 1, 2006-08 ,pp. : 45-61

Inderscience Publishers

Access to resources Recommend Favorite

Analysis and prediction of cutting forces in end milling by means of a geometrical model

By Tsai Chung-Liang  

The International Journal of Advanced Manufacturing Technology, Vol. 31, Iss. 9-10, 2007-01 ,pp. : 888-896

Springer Publishing Company

Access to resources Recommend Favorite

Modelling cutting forces in milling on torus cutters

By Gilles Patrick   Monies Frederic   Rubio Walter  

International Journal of Machining and Machinability of Materials, Vol. 1, Iss. 2, 2006-10 ,pp. : 166-185

Inderscience Publishers

Access to resources Recommend Favorite

Geometrical analysis of thread milling—part 2: calculation of uncut chip thickness

By Fromentin Guillaume   Poulachon Gérard  

The International Journal of Advanced Manufacturing Technology, Vol. 49, Iss. 1-4, 2010-07 ,pp. : 81-87

Springer Publishing Company

Access to resources Recommend Favorite

Modelling, simulation and experimental investigation of cutting forces during helical milling operations

By Liu Changyi  

The International Journal of Advanced Manufacturing Technology, Vol. 63, Iss. 9-12, 2012-12 ,pp. : 839-850

Springer Publishing Company

Access to resources Recommend Favorite