Related content

The development of an end-milling process depth of cut monitoring system

By Prickett Paul   Siddiqui Raees   Grosvenor Roger  

The International Journal of Advanced Manufacturing Technology, Vol. 52, Iss. 1-4, 2011-01 ,pp. : 89-100

Springer Publishing Company

Access to resources Recommend Favorite

Use of NC kernel data for surface roughness monitoring in milling operations

By Brecher Christian   Quintana Guillem   Rudolf Thomas   Ciurana Joaquim  

The International Journal of Advanced Manufacturing Technology, Vol. 53, Iss. 9-12, 2011-04 ,pp. : 953-962

Springer Publishing Company

Access to resources Recommend Favorite

Optimal cutting condition determination for desired surface roughness in end milling

By Prakasvudhisarn Chakguy   Kunnapapdeelert Siwaporn   Yenradee Pisal  

The International Journal of Advanced Manufacturing Technology, Vol. 41, Iss. 5-6, 2009-03 ,pp. : 440-451

Springer Publishing Company

Access to resources Recommend Favorite

The optimization of the surface roughness in the process of tangential turn-milling using genetic algorithm

By Savas Vedat   Ozay Cetin  

The International Journal of Advanced Manufacturing Technology, Vol. 37, Iss. 3-4, 2008-05 ,pp. : 335-340

Springer Publishing Company

Access to resources Recommend Favorite

Experimental evaluation of surface roughness for end milling of Al 6063: response surface and neural network model

By Sivasakthivel P.S.   Murugan V. Vel   Sudhakaran R.  

International Journal of Manufacturing Research, Vol. 7, Iss. 1, 2012-02 ,pp. : 9-25

Inderscience Publishers

Access to resources Recommend Favorite