Influence of process parameters on part shrinkage in SLS

Author： Wang Rong-Ji   Wang Lingling   Zhao Lihua   Liu Zijian  

Publisher： Springer Publishing Company

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.33, Iss.5-6, 2007-06, pp. : 498-504

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Calibration of shrinkage and beam offset in SLS process

By Wang Xiangwei  

Rapid Prototyping Journal, Vol. 5, Iss. 3, 1999-03 ,pp. : 129-133

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Advances in modeling the effects of selected parameters on the SLS process

By Williams John D   Deckard Carl R  

Rapid Prototyping Journal, Vol. 4, Iss. 2, 1998-02 ,pp. : 90-100

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

The influence of cavity deformation on the shrinkage and warpage of an injection-molded part

By Wu Cheng-Hsien   Huang Yu-Jen  

The International Journal of Advanced Manufacturing Technology, Vol. 32, Iss. 11-12, 2007-05 ,pp. : 1144-1154

Springer Publishing Company

Access to resources Recommend Favorite

Effects of injection molding parameters on shrinkage and weight of plastic part produced by DMLS mold

By Nagahanumaiah   Ravi B.  

Rapid Prototyping Journal, Vol. 15, Iss. 3, 2009-05 ,pp. : 179-186

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Influence of process parameters on scale reduction with H2

By Primavera A.   Cattarino S.   Pavlicevic M.  

Ironmaking & Steelmaking, Vol. 34, Iss. 4, 2007-07 ,pp. : 290-294

Maney Publishing

Access to resources Recommend Favorite