Effects of the cutting feed, depth of cut, and workpiece (bore) diameter on the tool wear rate

Author： Astakhov Viktor  

Publisher： Springer Publishing Company

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.34, Iss.7-8, 2007-10, pp. : 631-640

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Influence of cutting tool geometry, feed rate and cutting fluid on the machinability of Inconel 751

By Melo Anderson Clayton Alves de   Milan Julio Cesar Giubilei  

International Journal of Machining and Machinability of Materials, Vol. 9, Iss. 1-2, 2011-01 ,pp. : 16-34

Inderscience Publishers

Access to resources Recommend Favorite

An approach to reduce the influence of tool wear on workpiece properties during hard turning

By Denkena Berend   Meyer Roland  

International Journal of Microstructure and Materials Properties, Vol. 4, Iss. 5-6, 2010-02 ,pp. : 605-614

Inderscience Publishers

Access to resources Recommend Favorite

Tool flank wear influence on workpiece heating in dry machining

By Cohen Guillaume   Segonds Stephane   Mousseigne Michel   Lagarrigue Pierre  

International Journal of Machining and Machinability of Materials, Vol. 4, Iss. 4, 2009-03 ,pp. : 406-418

Inderscience Publishers

Access to resources Recommend Favorite

Atomistic and Experimental Investigation of the Effect of Depth of Cut on Diamond Cutting of Cerium

By Zhang Junjie   Shuai Maobing   Zheng Haibing   Li Yao   Jin Ming   Sun Tao  

Micromachines, Vol. 9, Iss. 1, 2018-01 ,pp. : 26-26

MDPI

Access to resources Recommend Favorite

Cutting behavior and related cracks in wear and fracture of ceramic tool materials

By Xu Chonghai   Huang Chuanzhen   Ai Xing  

The International Journal of Advanced Manufacturing Technology, Vol. 32, Iss. 11-12, 2007-05 ,pp. : 1083-1089

Springer Publishing Company

Access to resources Recommend Favorite