Optimization of turning parameters for surface roughness and tool life based on the Taguchi method

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.38, Iss.9-10, 2008-09, pp. : 896-903

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Taguchi method based optimization of cutting tool flank wear during turning of PR-Al/20vol.% SiC-MMC

By Manna Alakesh Bhattacharyya Bijay

International Journal of Machining and Machinability of Materials, Vol. 1, Iss. 4, 2007-02 ,pp. : 488-499

Inderscience Publishers

Access to resources Recommend Favorite

Modelling and Optimization of Tool Chip Interface Temperature and Surface Roughness in CNC Dry Turning of EN 24 Steel

Advanced Engineering Forum, Vol. 2016, Iss. 16, 2016-05 ,pp. : 7-15

Trans Tech Publications

Access to resources Recommend Favorite

An experimental investigation on the effect of turning parameters on surface roughness

By Thangavel P. Selladurai V.

International Journal of Manufacturing Research, Vol. 3, Iss. 3, 2008-07 ,pp. : 285-300

Inderscience Publishers

Access to resources Recommend Favorite

Modelling, optimisation and experimental validation of cutting parameters to achieve minimum tool wear and surface roughness in hard turning of AISI H11 tool steel

By Saini Sanjeev

International Journal of Materials Engineering Innovation, Vol. 3, Iss. 3-4, 2012-09 ,pp. : 295-315

Inderscience Publishers

Access to resources Recommend Favorite

Optimization of Process Parameters for Surface Roughness in Ultrasonic Machining of Polycarbonate Bullet Proof Glass and Acrylic Heat Resistant Glass by Taguchi and Grey Relational Analysis Approach

Advanced Engineering Forum, Vol. 2017, Iss. 23, 2017-09 ,pp. : 21-44

Trans Tech Publications

Access to resources Recommend Favorite