Investigation and optimization of lubrication parameters in high speed turning of superalloy Inconel 718

Author： Thakur Dinesh   Ramamoorthy B.   Vijayaraghavan L.  

Publisher： Springer Publishing Company

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.50, Iss.5-8, 2010-09, pp. : 471-478

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Influence of minimum quantity lubrication on the high speed turning of aerospace material superalloy Inconel 718

By Thakur D.G.  

International Journal of Machining and Machinability of Materials, Vol. 13, Iss. 2-3, 2013-04 ,pp. : 203-214

Inderscience Publishers

Access to resources Recommend Favorite

Performance of the minimum quantity lubrication technique in turning Inconel 718 at high cutting speed

By Silva Leonardo R.   Soares Cleide B.  

International Journal of Machining and Machinability of Materials, Vol. 5, Iss. 4, 2009-06 ,pp. : 401-416

Inderscience Publishers

Access to resources Recommend Favorite

Finite Element Method and Experimental Investigation of Hot Turning of Inconel 718

By  

Advanced Engineering Forum, Vol. 2016, Iss. 16, 2016-05 ,pp. : 24-32

Trans Tech Publications

Access to resources Recommend Favorite

Wear of mixed alumina ceramic tools in high speed facing of Inconel 718

By Arunachalam RM.  

International Journal of Machining and Machinability of Materials, Vol. 2, Iss. 3-4, 2007-10 ,pp. : 433-450

Inderscience Publishers

Access to resources Recommend Favorite

Intelligent selection of machining parameters in turning of Inconel-718 using multi objective optimisation coupled with MADM

By Asokan P.   Senthilkumaar J.S.  

International Journal of Machining and Machinability of Materials, Vol. 8, Iss. 1-2, 2010-08 ,pp. : 209-225

Inderscience Publishers

Access to resources Recommend Favorite