The transition algorithm based on parametric spline curve for high-speed machining of continuous short line segments

Author： Zhang Li   You You   He Jun   Yang Xue  

Publisher： Springer Publishing Company

ISSN： 0268-3768

Source： The International Journal of Advanced Manufacturing Technology, Vol.52, Iss.1-4, 2011-01, pp. : 245-254

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

B-spline tool offset of a free-form curve in the shoe last high-speed machining CNC system

By Hu Jun   Shen Hong   Zeng Shuishen   Wang Yuhan  

The International Journal of Advanced Manufacturing Technology, Vol. 30, Iss. 9-10, 2006-10 ,pp. : 864-869

Springer Publishing Company

Access to resources Recommend Favorite

Feedrate scheduling and jerk control algorithm for high-speed CNC machining

By Wan Daping   Wang ShiLong   Zhu CaiChao   Meng Fanming  

International Journal of Manufacturing Technology and Management, Vol. 17, Iss. 3, 2009-03 ,pp. : 216-231

Inderscience Publishers

Access to resources Recommend Favorite

Heat partition-based design of hard coatings in high-speed machining

By Akbar Faraz   Mativenga Paul   Sheikh Mohammad  

International Journal of Machining and Machinability of Materials, Vol. 14, Iss. 4, 2013-11 ,pp. : 363-386

Inderscience Publishers

Access to resources Recommend Favorite

An accurate NURBS curve interpolation algorithm with short spline interpolation capacity

By Dong Haitao  

The International Journal of Advanced Manufacturing Technology, Vol. 63, Iss. 9-12, 2012-12 ,pp. : 1257-1270

Springer Publishing Company

Access to resources Recommend Favorite

High-speed contouring control with NURBS-based C2 PH spline curves

By Jahanpour Javad   Tsai Mi-Ching   Cheng Ming-Yang  

The International Journal of Advanced Manufacturing Technology, Vol. 49, Iss. 5-8, 2010-07 ,pp. : 663-674

Springer Publishing Company

Access to resources Recommend Favorite