Optimisation of friction stir welding process parameters to weld cast aluminium alloy A413 – an experimental approach

Author： Jayaraman M. Sivasubramanian R. Balasubramanian V. Babu S.

ISSN： 1364-0461

Source： International Journal of Cast Metals Research, Vol.22, Iss.5, 2009-10, pp. : 367-373

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Modelling of 7050 aluminium alloy friction stir welding

By Kamp N. Reynolds A. P. Robson J. D.

Science and Technology of Welding & Joining, Vol. 14, Iss. 7, 2009-10 ,pp. : 589-596

Maney Publishing

Access to resources Recommend Favorite

Investigation of weld defects in dissimilar friction stir welding of aluminium to brass by radiography

By Esmaeili A Givi M K Besharati Rajani H R Zareie

Science and Technology of Welding & Joining, Vol. 17, Iss. 7, 2012-10 ,pp. : 539-543

Maney Publishing

Access to resources Recommend Favorite

Experimental Analysis of Residual Stress in Friction Stir Processed Cast AlSi9Mg Aluminium Alloy

Key Engineering Materials, Vol. 2016, Iss. 682, 2016-03 ,pp. : 18-23

Trans Tech Publications

Access to resources Recommend Favorite

Optimisation of process parameters in friction stir welding based on residual stress analysis: a feasibility study

By Tutum C. C. Hattel J. H.

Science and Technology of Welding & Joining, Vol. 15, Iss. 5, 2010-07 ,pp. : 369-377

Maney Publishing

Access to resources Recommend Favorite

Effect of Welding Parameters on the Microstructure and Strength of Friction Stir Weld Joints in Twin Roll Cast EN AW Al-Mn1Cu Plates

By Birol Yucel Kasman Sefika

Journal of Materials Engineering and Performance, Vol. 22, Iss. 10, 2013-10 ,pp. : 3024-3033

Springer Publishing Company

Access to resources Recommend Favorite