Chapter
Hydrogen Storage at High-Pressure
1.2.7. Power Electronic Converters
Chapter 2:
MATHEMATICAL MODELS
2.1. GENERAL MODELING PRINCIPLES
2.4. LEAD ACID ACCUMULATOR
Chapter 3:
SYSTEM INTEGRATION
3.2. OPERATING PRINCIPLES
3.2.2. Main Operating Rules
Rule 1. The Load Demand Should Always be Satisfied
Rule 2. The Electrolyzer and the Fuel Cell Should not Operate
Simultaneously
Rule 3. The Electrolyzer and the Fuel Cell Should Operate within
the Technical Specifications Set by the Unit Manufacturer
Rule 4. The Accumulator SOC Must be Maintained within Limits
Rule 5. During Power Surplus (State I), an Extra Load can be Attached,
Where as During Power Deficit (State II) a Back-Up Power Generation
Unit can be Utilized
3.3. POWER MANAGEMENT STRATEGIES
Power Management Strategy 1 (PMS1)
Power Management Strategy 2 (PMS2)
Power Management Strategy 3 (PMS3)
3.4. PARAMETRIC SENSITIVITY STUDIES
Chapter 4:
SYSTEM DESIGN AND OPTIMIZATION
4.2. DESIGN AND OPTIMIZATION OF ENGINEERING
SYSTEMS
4.2.1. Conventional and Optimization-Based Design
4.2.2. Generic Optimization-Based Design Framework
4.3. PREVIOUS RESEARCH DEVELOPMENTS IN THE
DESIGN OF RES-BASED POWER GENERATION SYSTEMS
4.4. SOURCES OF DESIGN COMPLEXITY
4.4.1. Integration of Sub-Systems
4.4.2. Alternatives for Power Utilization
4.4.3. Uncertain Behavior
4.5. DESIGN AND OPTIMIZATION OF RES-BASED POWER
GENERATION SYSTEMS
4.5.1. Problem Formulation
4.5.2. Optimization-Based Design Framework
4.5.3. Incorporation of Uncertainty
4.5.4. Optimization Algorithms
4.6.1. Problem Formulation
4.6.3. Uncertain Parameters
4.6.4. Constraints in the Form of a Power Management Strategy
4.6.5. Objective Function
4.6.6. Results and Discussion
Chapter 5:
SYSTEM AUTOMATION AND CONTROL
5.1. INFRASTRUCTURE AND SUBSYSTEMS
5.1.1. Interaction of Components and System Architecture
5.1.2. Basic Technical Data
5.1.3. System Integration
5.1.3.1 Electrical System
DC/AC Converters (Inverters)
5.1.3.2. Electrochemical System and Power Backup
Hydrogen Buffer Tank and Compression System
5.2. PROCESS MONITORING AND CONTROL
5.2.1. Monitoring and Control
5.2.2. Technical Challenges - Protocol Integration
5.2.3. Automated Procedure
Design, Optimization and Control of Stand-Alone Power Systems using Renewable Energy Sources and Hydrogen Production
( Energy Science, Engineering and Technology )
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.