Chapter
Floating Treatment Wetland as an Alternative for Water Quality Improvement: A Preliminary Study
Investigation of Modified Mangrove Bark on the Sorption of Oil in Water
Kinetic Study of PAHs Degradation in Produced Water Using Ti/RuO2 Anode
Langat River Basin Hydrologic Model Using Integrated GIS and ArcSWAT Interface
Modeling of Contaminant Transport and Groundwater Flow of Tamangapa Landfill in Makassar Indonesia
Optimization of Activated Sludge Physical Properties by Magnetic Field via Response Surface Modeling
POME Treatment Efficacy as Affected by Carrier Material Size in Micro-Bioreactor System
Possible Stabilization of Sludge from Groundwater Treatment Plant Using Electrokinetic Method
Post-Treatment of Anaerobically Digested Palm Oil Mill Effluent by Polymeric Flocculant-Assisted Coagulation
Prediction of Suspended Sediments in a Hyper – Concentrated River Using Neural Networks
Preliminary Investigation and Design Considerations for the Rehabilitation of Trash Screen at Jor Reservoir Low Level Outlet
Response of Partially Covered Road Embankments and its Environmental Impact
Survival of Pseudomonas putida for Biodiesel Blend (B5) in Soil Bioremediation
The Art of Integrated GIS/AHP for Siting Landfill: A Review
The Effects of Feedstock Sources and Pyrolytic Temperature on Biochars Sorptive Characteristics
The Impact of Stormwater Runoff on Nutrient Removal in Sand Columns
The Performance of Trapezoidal Glass Cover Solar still during Monsoon Period of Tropical Environment
Treatment of Wastewater Using an Integrated Submerged Attached Growth System
Volatile Fatty Acids Production through Degradation of Biomass by Anaerobic Digestion (Mesophilic and Thermophilic)
Water Quality Assessment of Ex-Mining Lakes in Perak, Malaysia as Alternative Source of Water Supply
Determination of Soil Polluted with Kerosene Using Electromagnetic Cell
Chapter 2: Coastal and Offshore Engineering
A Study on the Structural Failure Mechanism and Reserve Strength Ratio of Tarpon Monopods
A Study on Mooring Systems of an Offshore Floating Platform for Different Configurations
Behaviour of Mooring Systems for Different Line Pretensions
Broadside Vessel Collision Forces for Conventional Riser-Guard
Computational Aspects of Submarine Slide Generated Tsunami
Development of Platform Selection Tool for Offshore Decommissioning in Malaysia
Dynamic Response of Free-Span Sub-Sea Pipelines under Vortex Induced Vibrations
Dynamic Responses of Classic Spar Platform: Short Crested Waves vs. Long Crested Waves
Effect of Anodes on Hydrodynamic Coefficients of Tubular Cylinders - Model Tests
Effects of Marine Growth on Hydrodynamic Coefficients of Rigid Tubular Cylinders
Finite Element Assessment of Difficult Pipelines at Bends
Hydrodynamic Forces on Linear and Multi-Dimensional Arrays of Circular Cylinders
Investigation of Vortex Induced Vibration of Offshore Pipelines near Seabed
Multivariate Regression Analysis for Screening Process of Reliability Assessment
Performance of Mangrove Forests in Coastal Protection
Reliability Assessment Model for Aging Jacket Structures in Malaysian Waters
Resonant Motion of Liquid Confined between Floating Structures
Response of Monopod Platform under Extreme Wave in Malaysian Water
Seabed Condition from Single Beam Echo Sounder from Penang Port, Malaysia
System Reliability of Existing Jacket Platform in Malaysian Water (Failure Path and System Reliability Index)
Wave Attenuation of Interlocking Concrete Unit - V (ICU-V)
Wave Transmission over a Submerged Porous Breakwater an Experimental Study
Deformation Monitoring of Offshore Platform Using the Persistent Scatterer Interferometry Technique
Chapter 3: Structures and Materials
A Novel Method for Monitoring Hydration Process of Cement Paste Material
An Experimental Study on the Effects of Biaxial Bending due to Eccentric Load on RC Beam
Analytical Prediction of the Mechanical Properties of High Performance PVA Fiber Reinforced Concrete
Behaviour of Oil Palm Shell Reinforced Concrete Beams Added with Kenaf Fibres
Characterization of Stand Chopped Basalt Fiber Self – Compacting Reinforced Concrete (SCB-SCC)
Drying Shrinkage of Fly Ash-Based Self-Compacting Geopolymer Concrete
Durability of Sugar Cane Bagasse Ash (SCBA) Concrete towards Chloride Ion Penetration
Effect of Calcined Kaolin on the Mechanical Properties of High-Strength Concrete as Cement Replacing Material
Effect of Chopped Basalt Fiber on the Fresh and Hardened Properties of Fly Ash High Strength Concrete
Effect of Flexural Static Load on the Strength of GFRP Gratings
Effect of MIRHA and Fly Ash in Ductile Self-Compacting Concrete on Abrasion and Impact Performance
Effective Method of Repairing RC Beam Using Externally Bonded Steel Plate
Effects of Geopolymer Concrete Fly Ash Based on Alkali Silica Reaction (ASR)
Flexural Behaviour of Concrete Beams Bonded with Wire Mesh-Epoxy Composite
Interrelationship Analysis of Geopolymer Components Using Pearson Correlation Technique
Low Energy Compaction of Aggregate Packing Mechanism
Mechanical Properties of Engineered Cementitious Composites Mixture
Microwave Incinerated Rice Husk Ash (MIRHA) and Used Engine Oil (UEO): Towards Sustainable Concrete Production
Numerical Investigation of the Response of Protective Barrier under Blast Loading
POFA: A Potential Partial Cement Replacement Material in Oil Palm Shell Lightweight Aggregate Concrete
Precast Concrete Sheetpile for the Stabilization of Road Embankment on Soft Ground Adjacent to River
Precast Concrete Soldier Pile System with Corrugated Section Post for Riverbank Protection
Prediction of Failure Loads of RC Dapped-End Beams
Prediction the Shear Strength for FRP Shear Strengthened RC Beams Based on Optimised Truss Models
Predictive Stress-Strain Models for High Strength Concrete Subjected to Uniaxial Compression
Prospect of Adopting Kapok Fibre as Roof Insulation
Rehabilitation of RC Structures Exposed to Salinity and Moisture Using CFRP
Shear Capacity of RC Beams with Web Openings Strengthened with Multi Layers of CFRP
Single-Degree-of-Freedom Based Pressure-Impulse Diagrams for Blast Damage Assessment
Strength Development of Concrete Incorporating Metakaolin and PVA Fibres
Strengthening Schemes for Flexure and Torsion Using FRP Laminates: A State of Art Review
Tension Stiffening Analysis for Cyclically Loaded RC Beams
The Effect of MIRHA and Fly Ash on Mechanical Strength and Chloride Penetration Depth of DSCC
The Effect of Palm Oil Fuel Ash as a Cementreplacement Material on Self-Compacting Concrete
The Laminated Composite Thermosetting Pipe
The Utilization of Rice Husks Powder as an Antioxidant in Asphalt Binder
Unconfined Compressive Strength Performance of Cement Stabilized Peat with Rice Husk Ash as a Pozzolan
Chapter 4: Construction and Project Management
A Field Study of Mould Growth for Institute Higher Education Library Buildings in Malaysia
Challenges for Implementation of Building Information Modeling (BIM) in Malaysian Construction Industry
Embodied Carbon of Buildings: Tools, Methods and Strategies
Evaluation of Multi Storey Structures in Malaysia
Evaluation of Roofing Systems in Malaysia Based on MS 1553 BS 6399, EC1-1-4 and IS 875 Wind Codes
Implementation of Dam Safety Management Program in Malaysia: From Theory to Practice
Major Challenges to the Sustainable Operations of Construction Equipment in Malaysia
Number of Bidders in Small and Medium Public Construction Procurement in Malaysia
Private Finance Initiatives (PFI): Getting it Right
Resource Management in Construction Project
Risk Ranking of Malaysian Public Private Partnership Projects
Service and Construction Sector of Malaysia: Causality Link (1991-2013)
The Development of Building Information Modeling (BIM) Definition
The Effects of Orientations on the Room's Thermal Performance in the Tropics
The Importance of Lightweight Concrete Technology Development for IBS Industry in Malaysia Based on Cost Comparison between Concrete Slab and Hollow Core Slab: A Case Study of LRT Car Park Project
The Performance Measurement of Supply Chain Management (SCM) in Malaysian Infrastructure Project
Research on HGV Collisions with Concrete Bridge Piers
Analytic Network Process Approach to Risk Allocation of EPC Projects Case Study: Gas Refinery EPC Projects in Iran
Chapter 5: Building, Highway, Geotechnical, Transportation Engineering and Geoinformatics
A Review on the Factors Influencing the Park-and-Ride Traffic Management Method
Assessing UAV Landslide Mapping Using Unmanned Aerial Vehicle (UAV) for Landslide Mapping Activity
Assessment on Bearing Capacity of Two Clay Layers Soil Using COMSOL
Bearing Capacity of Shallow Foundation's Prediction through Hybrid Artificial Neural Networks
Comparison of Seismic Performance between Single and Double Unit Tunnel Form Building under In-Plane Lateral Cyclic Loading
Development Spectral Library of Vegetation Stress for Hydrocarbon Seepage
Distribution of Stress on Stone Column-Reinforced Soft Soil under Cylindrical Storage Tank
Effect of Soil Depth on the Quantification of Soil Moisture Content Value Estimated from NOAA Satellite Images
Erosion Assessment of Slope Failure Tragedies; A Case Study in Malaysia
Flood Disaster Forecasting: A GIS-Based Group Analytic Hierarchy Process Approach
Generation, Propagation, Run-Up and Impact of Landslide Triggered Tsunami: A Literature Review
Human Error Causes in Slope Engineering Practices
Measuring Driver’s Percent-Time-Spent-Following Using a Moving Video Recording Technique
Modeling Pedestrian Behavior in Rail Transit Terminal
Statistical Analysis of Dynamic Bearing Capacity of Driven Pile
The Use of Bitumen Linear Viscoelastic Properties to Assess Rutting Sensitivity
Time-Space Geography: A Creditable Transport Accessibility Measure for Rural Dwellers
Application of Geographic Information System (GIS) and Analytic Network Process (ANP) for Sustainable Tourism Planning in Cameron Highlands, Malaysia
Structural, Environmental, Coastal and Offshore Engineering
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
