Chapter
Oxide Spallation in Beta-NiAl Coated Systems under Mechanicalloading
Creep Deformation / Oxidation Behavior of Re-Cr-Ni Diffusion Barrier Coated Hastelloy-X at 970°C in Air
Study of the Microstructure and Oxidation Behavior of Chromium Base Alloys Strengthened by NiAl Precipitates
A Novel Duplex Re-NiW Based Diffusion Barrier on a Nickel-Base Superalloy for TBC Systems
Formation of Pt-Modified γ’-Ni3Al and Re-Based σ-Alloy Coating System and Cyclic Oxidation Behavior of Coated Superalloy
Preliminary Results of the Isothermal Oxidation Study of Pt-Al-NiCoCrAlYTa Multi-Layered Coatings Prepared by Sparks Plasma Sintering (SPS)
A Prototype Software Tool for Life Time Assessment of Thermal Barrier Coating Systems
Numerical Modelling of Diffusion Coupled with Cyclic Oxidation. Application to Alumina-Forming Coatings Used for Industrial Gas Turbine Blades
Chemistry of Ash-Deposits on Gas Turbines Hot Parts: Reactivity of Nickel, Zinc and Iron Oxides in (Na, V, S) Molten Salts
Hydrogen Detection in Buried Layers of Thermal Barrier Coatings
Aluminide Coating Formation on Internal Passages of GTD-111 Superalloy by Slurry Technique
Enigmatic Moisture Effects on Al2O3 Scale and TBC Adhesion
Phase Field Modeling of Interdiffusion Microstructure in Ni-Cr-Al Diffusion Couples
Degradation of Yttria Stabilized Zirconia Thermal Barrier Coatings by Molten CMAS (CaO-MgO-Al2O3-SiO2) Deposits
Characterization of TBC Systems with NiPtAl or NiCoCrAlYTa Bond Coatings after Thermal Cycling at 1100°C: A Comparative Study of Failure Mechanisms
Depth Distribution of Residual Stress in Graded (Ti, Al) N Coating and Fatigue Properties of Coated Stainless Steel
Solid Reactions between Enamel and O-Phase Ti-Al-Nb Intermetallics at 800 °C
Compositional Factors Affecting the Oxidation Behavior of Pt-Modified γ-Ni+γ’-Ni3Al-Based Alloys and Coatings
II. Power Boilers and Incinerators; H2 Singas and Biofuels Production
Microstructural Evolution of Slurry Fe Aluminide Coatings during High Temperature Steam Oxidation
Thermodynamic Modelling of the Corrosive Deposits in Oxy-Fuel Fired Boilers
Development of a Laboratory-Scale Pilot for Studying Corrosion on MSWI Heat Exchangers
Fireside Corrosion in Energy Recovery Boilers and Maintenance Issues
Fireside Corrosion of Stainless and Low Alloyed Steels in a Waste-Fired CFB Boiler; The Effect of Adding Sulphur to the Fuel
Steam Oxidation of Advanced Steam Turbine Alloys
New Approaches to Improve High Temperature Corrosion Resistance in Chlorine-Based Atmospheres
Comparison between Current Methods for Measurement of High Temperature Corrosion of Boiler Steels in Steam Environments
Scale Growth on Austenitic Alloys under KCl Deposits at 500°C
Study of Oxyhydroxides Formation on P92 Steel on Al-CVD Coating in Contact with Ar+20% H2O at 650°C by TG-Mass Spectrometry
Al-Mn CVD-FBR Protective for Steam Corrosion Applications
Evaluation of Al-Hf Coating on Ferritic Steels by CVD-FBR Technology in Steam Oxidation
Alkali Induced Corrosion of 304-Type Austenitic Stainless Steel at 600°C; Comparison between KCl, K2CO3 and K2SO4
Corrosion in Biomass Combustion Systems
Development of Strain in Oxides Grown in Steam Tubes
Slag-Refractory Interaction in Slagging Coal Gasifiers
III. HT Materials for Nuclear Processes
Altering Corrosion Response via Grain Boundary Engineering
Modelling of Corrosion Induced Stresses during Zircaloy-4 Oxidation in Air
Thermodynamic Modelling of the Destruction of the Surface Cr2O3 on Alloy 230 in the Impure Helium Atmosphere of a Gas Cooled Reactor
Comparison of the High Temperature Surface Reactivity in Impure Helium of Two Materials for Gas Cooled Reactors
Kinetic Study of the Low Temperature Internal Oxidation of Nickel Based Model Alloys Exposed to PWR Primary Water
Chemical Evolution in the Substrate due to Oxidation: A Numerical Model with Explicit Treatment of Vacancy Fluxes
Corrosion of T91 Steel in LBE: Contribution to the Study of the Pb–Bi–O–Fe–Hg System - Thermodynamic Description of PbO–Fe2O3
Electrochemical Study of the Corrosion of Metals in Molten Fluorides
Influence of Al on the High Temperature Corrosion Behaviour of Inconel 617 in VHTR Primary Coolant Atmosphere
Oxide Layers Mechanical Properties for Ni Base Alloys in HTR Environment
A Review of Haynes® 230® and 617 Alloys for High Temperature Gas Cooled Reactors
High Temperature Oxidation of Fe-9Cr-1Mo Steel in Liquid Metal
Corrosion Mechanisms of Ni-Base Alloys in Pressurized Water Reactor Primary Conditions
Characterization of the Oxide Films Formed at the Surface of Ni-Base Alloys in Pressurized Water Reactors Primary Coolant by Transmission Electron Microscopy
Overview of Coating and Compatibility Research for Fusion Energy in the U.S.
New Experimental Loops for Research Reactor LVR-15
Imaging by Photoelectrochemical Techniques of Laves-Phases γ Zr(Fe,Cr)2 Thermally Oxidized on Zircaloy-4
IV. HT Corrosion in the Process Industries
An Expert Software for Multi-Layer Coatings Design in Surface Engineering
Oxidation of Stoichiometric Nickel Ferrites Used as Inert Anodes for Aluminium Electrolysis in Molten Cryolite Mixtures
Short Term Oxidation of Stainless Steels during Final Annealing
Corrosion of MA754 and MA956 in a Commercial Aluminum Melter
Relationship between Chromia Solubility and Superalloy Corrosion in Silicate Melts – A First Attempt
The Oxidation Behaviour of Pack-Treated Heavy Refractory Alloys
Corrosion of Lead Glasses by SO2 Gas
Metal Dusting Behaviour of Alloy800H in Laboratory Carbonaceous Environments under High Pressure
Oxidation Behavior of Wrought Gamma-Prime Strengthened Alloys
Characterization and Failure Analysis of Incoloy 800 Used as Thermowell Subjected to High Temperature Erosion-Corrosion
Mechanism of Catalytic Coke Formation and Some Means to Limit it in Refinery Processes
Modelling the Development of Type I Hot Corrosion on Coated and Uncoated Single Crystal Superalloys
Enhanced Internal Oxidation as Reason for Breakdown of Protective Chromia Scales on FeCr-Alloys in Water Vapour Containing Gases
Cyclic Oxidation of Two FeCrAlRE Foils at 1100 °C - The Influence of the Concentration of Minor Alloying Elements on Scale Microstructure
V. HT Corrosion of Functional Materials and Coatings
Evaluation of Al2O3 MOCVD Coating for Titanium Alloys Protection under Severe Conditions at High Temperature
On the Loss of Protective Scale Formation in Creep-Resistant, Alumina-Forming Austenitic Stainless Steels at 900°C in Air
Effect of Lanthanum Sol-Gel Coating on the Oxidation Behaviour of the AISI 304 Steel at 1000°C
High Temperature Corrosion of the Si-Mo Cast Iron in Exhaust Atmosphere
On the Effect of Surface Treatment to Improve Oxidation Resistance and Conductivity of Metallic Interconnects for SOFC in Operating Conditions
High Temperature Sulphidation Behavior of Fe20Cr6Al-Y,Hf Steel
Multifunction High Temperature Coating System Based on Aluminium Particle Technology
Investigation of Oxide-Nucleation on Ferritic FeCr Interconnect Alloys for Solid Oxide Fuel Cells Exposed to Anode and Cathode Gases at 850°C
Oxidation and Corrosion Effects on Thermal Fatigue Behaviour of Hot Work Tool Steel X38CrMoV5 (AISI H11)
Investigation of Thin Coatings from Mn-Co-Fe System Deposited by PVD on Metallic Interconnects for SOFC Applications
The Effect of Ca-Rich Deposits on the High Temperature Degradation of Coated and Uncoated Superalloys
Perovskite and Spinel Functional Coatings for SOFC Metallic Interconnects
A Model for Transitions in Oxidation Regimes of ZrB2
Investigation of the Development Processes of Self-Organizing, Protective Oxide Scales and Wear Resistant Surface Layers on the Fe-44%Cr-1%Ni-4%Al-0.3%La Alloy
The Effect of Water Vapour and Sulphur on Corrosion Mechanisms of Steels
Effects of Microstructural Arrangement on Hot Corrosion Resistance of a Pb-Sb Alloy for Battery Grids
Influence of Tantalum on the Rates of High Temperature Oxidation and Chromia Volatilization for Cast (Fe and/or Ni)-30Cr-0.4C Alloys
Study of the Behavior in Oxidation at High Temperature of Ni, Co and Fe-Base Alloys Containing Very High Fractions of Carbides
Microstructure Influence on Residual Stresses in Growing Chromia Oxide Films as Determined by In Situ High Temperature Raman Spectroscopy
High Resolution MicroRaman Study of Blisters in Cr2O3 Thermal Oxide Films
Yttrium Implantation and Manganese Addition Element Effects on the High Temperature Oxidation Resistance of a Model Steel
Comments on the Quantification of Mechanical Adhesion Energy of Thermal Oxide Scale on Metallic Substrate Using Tensile Test
Thermal Alumina Scales on FeCrAl: Characterization and Growth Mechanism
Relation between Synthesis Process, Microstructure and Corrosion Resistance of Two Yttrium Silicates
The Effects of Reactive Element Oxide Coatings on the High Temperature Oxidation of FeCrAl Alloy
Thermal Fatigue of Anticorrosive Coatings and Multilayer Coatings: A Performance Index Approach
Influence of Interstitials Content on the Sensitivity of Alloy 718 to Oxidation Assisted Intergranular Fracture
Oxidation Behavior of Mo Containing Alloys
Oxidation of Some Titanium Alloys in Air at Elevated Temperatures
Direct Measurements of the Chromium Activity in Complex Nickel Base Alloys by High Temperature Mass Spectrometry
The Nitridation, a Way to Improve High Temperature Oxidation Behaviour of AISI 304
High Temperature Oxidation and Oxidation-Induced Degradation of Alumina Formers
The Influence of H2O on Iron Oxidation at 600°C: A Microstructural Study
The Effect of Additional Elements on Oxide Scale Evolution of Fe-20at.%Cr-10at.%Al Alloy at 900 °C in Air
On the Mutual Interaction between Mechanical Stresses and Internal Corrosion during Isothermal and Cyclic Oxidation of Nickel-Base Superalloys
Thermal Effects of Continuous Laser Treatment on Ti-6 Al(wt%)-4V(wt%) Titanium Alloy
Void Formation in Growing Oxide Scales with Schottky Defects and P-Type Conduction
Oxidation and Nitridation of Pure Chromium at Elevated Temperature in Synthetic Air – Effect of Silicon Addition
The Effect of Copper and Ceria Additions on the High Temperature Oxidation of Nickel
Oxidation Performance of High Temperature Mo-Si-B Alloys and Coatings
The Effect of CaO Coatings on the Oxidation Behaviour of Polycrystalline Nickel between 800 and 1200 °C
The Effect of Thermal Expansion on Spallation Behavior of Fe-Base Alumina-Forming Alloys
Void Formation and Filling under Alumina Scales Formed on Fe-20Cr-5Al Alloy Thin Foils
The Role of Zr in the High-Temperature Oxidation of Fe3Al
Why the Growth Rates of Alumina and Chromia Scales on Thin Specimens Differ from those on Thick Specimens
Impedance Spectroscopy Applied to Metal Corrosion Study in Silicate Melts
Manganese Effect on Isothermal High Temperature Oxidation Behaviour of AISI 304 Stainless Steel
In Situ Thermal Gradient Controlled Investigation of Spallation -Experimental Design and Preliminary Results
Ternary and Quaternary Interdiffusion in γ (fcc) Fe-Ni-Cr-X (X = Si, Ge) Alloys at 900°C
Kinetics of Some Iron-Based Alloys in Industrial CO2: Formation of Wüstite Phase
Cyclic Oxidation Behavior of Sputtered Nanocrystalline Coating with Yttrium Additions in Air
Use of the Sessile Drop Method to Understand the Behaviour of Self Healing Ceramic Matrix Composite
Photoelectrochemical Characterisation of Chromia Scales Thermally Grown on Various Metal Substrates
Effects of Water Vapour on the Oxidation of Chromia Formers
High Temperature Corrosion and Protection of Materials 7
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
