Chapter
Mechanical Properties of Fe-6.5%Si Ribbons Produced by Planar Flow Casting
Structural Model of Ultrafine Grained Materials Produced by Severe Plastic Deformation
High Temperature Stability of an Al-Zr-Ti Alloy
Changes of Phase Composition in Nanocrystalline Fe-C and Fe-Ni-C Induced by Severe Deformation
Structural Investigations of Ultrafine Grained Germanium Produced by Severe Plastic Deformation
Plastic Deformation of Fine-Grained Structures Produced from Amorphous Alloys at Elevated Temperatures
On a Physical Nature of the Yield Stress Anisotropy of Amorphous Alloys Ribbons
Stress Induced Reordering in Amorphous Metals Analyzed by Relaxation Time and Activation Energy Spectrum Model
On Causes of High Local Plasticity of a Bulk Cu50Zr35Ti8Hf5Ni2 Amorphous Alloy during Low Temperature Shear Failure under Compression
Superplasticity in Ultrafine-Grained Materials
Microstructure and Mechanical Properties of Ultrafine-Grained Materials
Phenomenological and Mechanistic Approaches to Optimal Structural Superplasticity
Superplasticity in a Powder Metallurgy Al-Zn-Mg-Cu-Zr Alloy
Investigation of the High Temperature Plasticity of Materials by Indentation Measurements
The Interpretation of Hardness Measurements Applied for the Determination of the Strain Rate Sensitivity
Grain Boundary Character Distribution and Mechanical Properties of Austenitic Stainless Steels
Plastic Deformation of Ordered Intermetallic Alloys: Fundamental Aspects
The Stress Anomalies in TiAl: A Consequence of Mobile Dislocation Exhaustion
Non-Equilibrium Dissociations of Dislocations
Determination of the Dislocation Structure in Fe70Al30
Directional Coarsening in Single Crystal Nickel Based Superalloys: A Simulation
Strain and Strain Rate Softening Instabilities: Length Scales and Spatial Couplings
On the Relations between Portevin Le Châtelier Plastic Instabilities and Precipitation
Onset of Discontinuous Flow in Cu-Be Alloys
Jerky Flow in Al-Li-Mg-Cu Alloy
The Portevin-Le Châtelier Effect in Cu-Al Single Crystals Investigated by Acoustic Emission and Slip Line Cinematography
Structural Aspects of Portevin-Le Châtelier Phenomenon in Polycrystalline Alpha Titanium
Dynamical Effects in Crystal Plasticity
Effects of Non-Equilibrium Vacancies on Strengthening
Kinetics of Plastic Deformation
Introduction of 'Equivalent Deformation Mechanisms' for the Description of FCC Crystals Post-Stage-II Plasticity Kinematics
Microstructure and Strain Hardening of Steels
Evolution of Microstructural Parameters in Large Strain Deformation: Description by Zehetbauer's Model
Large Strain Deformation of Al-Cu Solid Solutions Using Channel-Die Compression
Microstructure and Mechanical Properties of A 6063 Aluminium Alloy at High Temperature
Dynamic Recovery in Cu-9Ni Alloy at Low Temperatures
Softening during Deformation of Zr Alloys
Description of the Deformation Behaviour of Al-5Zn-1.2Mg Alloy
The Relation between Forest Dislocations and Stress in BCC Metals
Short Range Interaction between Dislocations
Interpretation of Primary Creep Based on Constant Structure Experiments
Analysis of Constant Structure Behaviour in Zinc
The Effect of the Prestrain on Shearing Stress of Zinc Monocrystals in the (0001) System
Acoustic Emission from Deformed Zn Single Crystals
Plastic Deformation of Polycrystalline Zn-0.25%Cd Alloy and Linear Location of Acoustic Emission
Effect of Sense of Loading on Martensitic Transformations in Cu-Al-Ni Single Crystals
Orientation Dependence of σ-T Phase Diagrams for Martensite Transformations in Cu-Al-Ni Single Crystals
Effect of Deformation Mechanisms on Dynamic Recrystallization of Ferrite Stainless Steel
Plasticity of Cubic Zirconia between 700°C and 1150°C Observed by Macroscopic Compression and by In Situ Tensile Straining Tests
Internal Stresses and Microstructure in Plastically Deformed Metals and Alloys as Revealed by Asymmetric X-Ray Line Broadening
Long-Range Internal Stresses in the Transition from Cell to Subgrain Structures
Elastic-Plastic Response of Cracked Crystals
Low-Temperature Dislocation Relaxation Processes in Niobium of Different Purity
An Unified Model of Sweeping and Drift Mechanisms of the Formation of Dipolar Dislocation Structures
Dipolar Dislocation Patterns in the Primary Slip Plane
One Dimensional Model of Vein Structure Evolution
A Model of Long-Range Internal Stresses and Glide Dislocation Shapes in Dislocation Wall Structures
On the Localization of the Plastic Flow in Polycrystals of Austenitic Stainless Steel
Plasticity of Metals and Alloys
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
