Ceramic Tools with Ordinary and Wiper Inserts in Near Dry Machining with High Speed on Super Alloy Monel K500

ISSN： 1042-6914

Source： Materials and Manufacturing Processes, Vol.29, Iss.5, 2014-05, pp. : 579-584

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Failure analysis of K-monel 500 (Ni-Cu-Al alloy) bolts

By Es-Said O.S. Zakharia K. Zakharia Z. Ventura C. Pfost D. Crawford P. Ward T. Raizk D. Foyos J. Marloth R.

Engineering Failure Analysis, Vol. 7, Iss. 5, 2000-10 ,pp. : 323-332

Elsevier

Access to resources Recommend Favorite

Effect of high temperature exposure on the microstructure of Udimet-500 super alloy

By Ejaz Noveed Mansoor Muhammad Salam Iftikhar

Journal of Materials Science, Vol. 45, Iss. 16, 2010-08 ,pp. : 4507-4517

Springer Publishing Company

Access to resources Recommend Favorite

Wear Analysis of ZTA-MgO Ceramic Cutting Inserts on Stainless Steel 316L Machining

Advanced Materials Research, Vol. 2015, Iss. 1087, 2015-03 ,pp. : 101-105

Trans Tech Publications

Access to resources Recommend Favorite

The performance of TiN-coated high speed steel tool inserts in turning

By Lim C.Y.H. Lim S.C. Lee K.S.

Tribology International, Vol. 32, Iss. 7, 1999-07 ,pp. : 393-398

Elsevier

Access to resources Recommend Favorite

Delay induced canards in a model of high speed machining

By Campbell Sue Ann

Dynamical Systems: An International Journal, Vol. 24, Iss. 3, 2009-09 ,pp. : 373-392

Taylor & Francis Ltd

Access to resources Recommend Favorite